Bryant All models error codes
Codes
- P6Error codeLow pressure protection (Only for the outdoor unit with pressure switch)
- P61Error codePI Mode: 05 = reverse, 0---5V, 01 = no PID
- P62Error codeMin feedback = 0 (0V *10)
- P63Error codeMax feedback = 50 (5V * 10)
- P64Error codeProportional gain = 3.5% 3.5 3.5 3.5
- P65Error codeIntegral gain = .2 .2 .2 .2
- P66Error codePI accel/decel (setpoint change filter) = 10
- PC00Error codeODU IPM Module Protection
- PC0LError codeLow Ambient Temperate Protection
- PC01Error codeODU Voltage Protection
- PC02Error codeCompressor To (or IPM Module Protection
- PC03Error codePressure Protection (Low or High Pressure)
- PC04Error codeInverter Compressor Drive Error
- PEError codePower exhaust
- PFError codeCurrent Overload Fault Automatic mechanical problem with the driven
- PHError codeCPHEATER kW V
- PL1Error codeC LEANER LEANER ELECTRO AUTOMOTIVE BREAKER (115 SWITC AUTO-RESET
- PL2Error codeGRN/YEL -1 ITOR .) RY RED
- PL3Error codeIRCUIT C SWITC
- PL4Error codeLOCKOUT run secondary
- PL7Error code3 2 8 5 6 9 furnace auto-reset
- PR1Error codeRELAY, CONNECTION CONNECTION AMP. SELECTOR
- R-454BError codeThe indoor unit provides quiet, maximum comfort. In addition to cooling
- R1Error codeRed in the DC capacitors. If this LED is lit then a
- R38Error codeC2 Low Pressure
- RAError code= Percent of Return Air
- RCError codeREMOVE J1 FOR 24VAC Hot Cooling
- RHError code24VAC Hot Heating
- RSError codeRollout switch gas section switch input J2, 5-6
- RXError codeThe RTU Open controller is receiving data from the network segment
- SBError codeTemperature accuracy –0°F/+2°F
- SDError codePower abnormal detection
- SFError codeSingle---Phase Fault Automatic Check input power phasing.
- SOError codeCAUTION C7400
- SRError codeEquipment Damage Hazard.
- SSError codeSpeed sensor gas section analog input J1, 1-3
- T1Error codeFROM FACE OF BODY
- T2Error codeCompressor T2
- T3Error code0.596 Line C
- T4Error codeOutdoor ambient temperature
- TBError codeTerminal Block
- TH1Error codeture of air entering the dimpled heat exchanger is 50°F continu
- TH2Error codeperatures, a field-supplied outdoor-air thermostat must be used to
- TMError code= Mixed-Air Temperature
- TOError codethan 72 hours (actual time).
- TPError code— Thermal Protector
- TP-1Error codecompressor. Since a compressor is designed to pump refrigerant in
- TP-2Error codesystem. Operate system in both modes several times to be sure
- TP-4Error codeTP-3 ACCURATE
- TRError code= Return-Air Temperature