Bryant All models error codes
Codes
- 1-4Error codeDissipation Mode for 60 seconds DEMAND FAN GAS HEAT
- 3-6Error codeft-in. 0-115⁄8 0-117⁄8 41⁄8 41⁄2
- 4Error codePressure Switch Open Or Shorted
- 4-06Error codePC 101 Printed in U.S.A. Pg 52
- 5Error codeFlame Failure Or Flame Sensing Issue
- 5-29LED codeDisplay flash code history
- 6Error codeGas Valve Or Inducer Problem
- 7Error codeLow Supply Voltage Or Control Fault
- 8Error codeInternal Control Board Failure
- 9Error codeIgnition Lockout / Repeated Failures
- 11-19Error codeReplaces: IIK-CRECOMZ52-01
- 28-32Error codeFor installations below 2000 Ft. (610 M), refer to the unit
- 32-36Error codemultiply the input on the rating plate by the de--rate multi
- 36-40Error code2. Determine the correct orifice and manifold pressure adjust
- A1Error codeAmber On when 12V source is normal.
- A2Error codeAmber On when the main relay is closed.
- ACError codeAC AC AC AC AC AC AC
- AFError codeHigh Temperature Fault Automatic Check cooling fan operation.
- APError codeAP mode of WIFI connection
- ASError code(LO) C INDUCED INDUCED LING
- ATError codethe problem is or
- B1Error codeL1 P1 B2 L2 P2
- BEError codepolarity. test
- BO-1Error codeBO-2 BO-3 BO-4 BO-5
- BYError codeREOPENED inducer Disconnected blower sensor
- CFError codeControl Fault Manual
- CHError code— Crankcase Heater RCV — Receiver
- CLError codeFilter cleaning reminder
- CNError code— Connector RVS — Reversing Valve Solenoid
- CN1Error code
- CN2Error code
- CN3Error codeEarth: connect to Ground
- CN6Error codeUsed for testing
- CN7Error codeConnect to DC Fan
- CN8Error codeP1_1 CN3 CN20
- CN16Error codeS: connect to indoor unit
- CN17Error code
- CN21Error codeConnect to pipe temperature sensor T3, ambient temperature sensor T4, exhaust temperature sensor TP
- CN25Error codeConnect to AC fan
- CN28Error code
- CN29Error codeOV AC (standby)
- CN30Error code
- CN31Error codeConnect to Electric Expansion Valve
- CN45Error codeCN46 DISPLAY BOARD
- CN60Error code
- COError codeConvenient outlet AB = 224 v
- CPError codeRemote switched off
- CRError code— Control Relay
- CSError codeCentrifugal switch (not used) switch input J2, 9-10
- D1Error codeMODES Dry Contact 1