Bryant All models error codes
Codes
- NFError codeFilter replacement reminder
- OAError code2-wire (18 to 22 AWG)
- OFError codeOutput Transistor Fault Automatic acceleration values. If
- OLError codeC TO (115VAC (24VAC)
- OMError code#6 SEC-2 NEUTRAL COOL HI) NOTE
- ONError codeMinimum position Closed
- ON-04Error codestatus (115V
- ORError code#11 instructions
- P0Error codeIPM malfunction or IGBT over-strong current protection Page 40
- P01Error codeLine Voltage: 01 = low line, 02 = high line
- P02Error codeCarrier Freq: 01 = 4 kHz, 02 = 6 kHz, 03 = 8 kHz
- P2Error codeHigh temperature protection of IPM module
- P04Error codeStop mode: coast to stop
- P4Error codeInverter compressor drive error
- P06Error codeTB---14 output: 01 = none
- P09Error codeTB---31 Output: 01 = none
- P10Error codeTB---13A function sel: 01 = none
- P11Error codeTB---13B function sel: 01 = none
- P12Error codeTB---13C function sel: 01 = none
- P13Error codeTB---15 output: 01 = none
- P14Error codeControl: 01 = Terminal strip
- P15Error codeSerial link: 02 = enabled 9600,8,N,2 with timer
- P16Error codeUnits editing: 02 = whole units
- P17Error codeRotation: 01 = forward only, 03 = reverse only
- P19Error codeAcceleration time: 20 sec
- P20Error codeDeceleration time: 10 sec
- P21Error codeDC brake time: 0
- P22Error codeDC BRAKE VOLTAGE 0%
- P23Error codeMin freq = 8 Hz ~ 100 – 160 rpm
- P25Error codeCurrent limit: (%)
- P26Error codeMotor overload: 100
- P27Error codeBase freq: 60 or 50 Hz
- P28Error codeFixed boost: 0.5% at low frequencies 0.5 0.5 0.5
- P29Error codeAccel boost: 0%
- P30Error codeSlip compensation: 0%
- P31Error codePreset spd #1: speed if loss of control signal
- P32Error codePreset spd #2: 0
- P33Error codePreset spd #3: 0
- P35Error codePreset spd 5 default — R134a setpoint. TB12---2 closed 12.6 12.6 12.6
- P36Error codePreset spd 6 default
- P37Error codePreset spd 7 default
- P38Error codeSkip bandwidth
- P39Error codeSpeed scaling
- P40Error codeFrequency scaling 50 or 60 Hz
- P41Error codeLoad scaling: default (not used so NA)
- P42Error codeAccel/decel #2: default (not used so NA)
- P43Error codeSerial address
- P44Error codePassword:111
- P47Error codeClear history? 01 = maintain. (set to 02 to clear)
- P48Error codeProgram selection: Program 1 – 12