Bryant All models error codes
Codes
- FPError codeHeating in room temperature under
- FRError codeFan Relay
- FTError codeCoefficient Heating
- FT3Error codeTable 7 shows the approved temperature rise range for each heating
- FU2Error codeBOARD R ONNEC RMER-115VAC (115VAC )
- G1Error codeGreen Blinks when the VFD receives a message from PCM.
- G2Error codeGreen On when VFD is in normal status. It is off when VFD is fault status.
- G3Error codeGreen closed. The signal of relay is controlled by
- GFError codeData Fault Manual
- GOError codeNO the install
- GVError codelegend. for will heat
- H1Error codebreaker requirements and disconnect switch size and L1: RED
- H4Error codenational and local codes when selecting wire size, fuse or L2: GRA
- HAError code— Home Automation
- HCError code— Heater Contactor
- HFError codeHigh DC Bus Voltage Fault Automatic
- HIError code1 2 PL1-6 PL1-8 PL1-2 PL1-4 PL1-5 PL1-1 conductors internal conditions, heat 150
- HI-02Error code2 PL1 4 10 5 1 9 7 3 11
- HPError codeHeating Capacity Total kW
- HSError code— Hall (RPM) Sensor
- HZError codePower Supply to Unit Volts Phase
- I2Error codeB2 L2 P2 I1 B1 L1 P1
- IFError code115V door the do
- INError codeSCHEMATIC GAS CAP - NOTE
- ISError codeIs to Is G a
- IS-03Error codehours. wire. voltage
- ITError codeSECONDARY circuit circuit.
- J1Error codeJ2 VAC VAC VAC VAC
- J2Error codethe (BLWM) are four
- J3Error codeInput_3 Input_5 Input_8
- J11Error code(0-10V or 2-10V)
- J13Error code(Reversing Valve/High Speed Fan/Y3)
- J20Error codeExample set for
- JFError codeSerial Fault Automatic indicating that the serial link has been P15. Check settings in
- K1Error codeK2 K3 OUTPUT SPEED
- KGError code1066.8 1270 compressor of
- KWError codeHeating Capacity Total Btuh
- L1Error codeBLOWER WER WER R BLOWER WER JUNCTIO
- L1-01Error codeHUM Y1 G Use This
- L2Error codePR1 NOTE must (IDM) lead or
- LBError codeCurb Weight lb
- LFError codeLow DC Bus Voltage Fault Automatic Line voltage is too low
- LLError codeRemote or Wire controller Lock
- LOError coderated control and NEUTRAL see
- LSError codeswitches pump
- LS1Error codeLGPS included block. trials-for-ignition.
- LS2Error code(WHEN GRN/YEL CONNECTOR CONNECTOR
- MMError codeallow minimum arrange
- N1Error codeDEGREES FAHRENHEIT
- NAError codeNA 4.4 Vdc 2 to 10 Vdc Only displayed if set up for 2 speed unit