Xinje VFD-manual error codes
Codes
- P7-15Error codeSecond time fault bus voltage
- P7-16Error codeSecond time fault input terminal status
- P7-17Error codeSecond time fault output terminal status
- P7-18Error codeSecond time fault VFD status
- P7-19Error codeSecond time fault power on time
- P7-20Error codeSecond time fault operation time
- P7-21Error codeLocation information of the second time fault
- P7-23Error codeFirst time fault frequency
- P7-24Error codeFirst time fault current
- P7-25Error codeFirst time fault bus voltage
- P7-26Error codeFirst time fault input terminal status
- P7-27Error codeFirst time fault output terminal status
- P7-28Error codeFirst time fault VFD status
- P7-29Error codeFirst time fault power on time
- P7-30Error codeFirst time fault operation time
- P7-31Error codeLocation information of the first time fault
- P7-33Error codeMotor overload protection mode selection
- P7-34Error codeMotor overload protection gain
- P7-35Error codeMotor overload warning coefficient
- P7-41Error codePower on ground short circuit protection function
- P7-42Error codeAction selection of fault relay during automatic fault reset
- P7-43Error codeInterval time of fault automatic reset
- P7-44Error codeFault automatic reset times
- P7-45Error codeProtection action selection 1 when fault
- P7-46Error codeProtection action selection 2 when fault
- P7-47Error codeProtection action selection 3 when fault
- P7-48Error codeProtection action selection 4 when fault
- P7-52Error codeBrake starting voltage
- P7-55Error codeOver voltage stall gain
- P7-56Error codeOver voltage stall protection voltage
- P7-67Error codeSelection of instantaneous stop non-stop function
- P7-68Error codePause judgement voltage of transient stop action
- P7-69Error codeJudgment time of instantaneous stop non-stop voltage rising
- P7-70Error codeJudgement voltage of instantaneous stop non-stop action
- P8Error code1: Restore factory parameters, excluding motor parameters, P0-13 and P0-15 2: Clear record information 3: Restore factory parameters (including motor parameters)
- P8-02Error codeParameter initialization
- P8-07Error codeLED operation display parameter 1 (Low 16 bits)
- P8-19Error codeInverter module radiator temperature
- P9-00Error codeCommunication protocol selection
- P9-02Error codeCommunication baud rate
- P9-04Error codeCommunication timeout
- P9-07Error codeVB3/VB5/V5 communication control words (3742 and above versions support)
- PA-01Error codeSetting channel selection
- PC-18Error codeFrequency detection value (FDT1 voltage level)
- PC-20Error codeFrequency detection value (FDT2 voltage level)
- PC-21Error codeFrequency detection hysteresis value (FDT2 voltage level)
- PC-34Error codeCurrent arrival detection value 1
- PC-35Error codeCurrent arrival detection 1 range
- PC-36Error codeCurrent arrival detection value 2
- PC-37Error codeCurrent arrival detection 2 range