Markasi-Belli-Degil All models error codes
Codes
- F00AError codeTarget processor cannot put requested information in packets
- F00BError codePrivilege error; access denied
- F00CError codeRequested function is not available
- F00DError codeRequest is redundant
- F00EError codeCommand cannot be executed
- F00FError codeOverflow; histogram overflow
- F01Error codeStore it at room temperature (approx. 20° C) for one day
- F1Error codeSu taşmasına karşı alarm aktif
- F1-05Error codeFull beam light left.
- F01AError codeFile owner active - the file is being used
- F01BError codeProgram owner active - someone is downloading or editing online
- F01CError codeDisk file is write protected or otherwise not accessible (offline only)
- F01DError codeDisk file is being used by another application
- F02Error codeThe battery is too cold Store it at room temperature (approx. 20° C) for oneday.
- F03Error codeThe battery is overloaded.
- F04Error codeThe battery is defective A defective battery is not allowed to be used any more
- F05Error codeThe battery is partially fully discharged Recharge the battery
- F008Error codeCannot complete request
- F009Error codeData or file is too large
- F10Error codeRuns all marked tests.
- F10-15Error codeWiper rear (KL15).
- F011Error codeData type requested does not match data available
- F11Error codeThe drive size setting has Check VFD fault code before turning off power. Check
- F11-10Error codeX07 / Radio / Supp. sw. work l. rear (KL15).
- F012Error codeIncorrect command parameters
- F12Error codeWasher controller internal Check VFD fault code before turning off power. Turn
- F12-10Error codeUpper dashboard/ Sw. Mirror Adj./Spare Switches (KL15).
- F013Error codeAddress reference exists to deleted area
- F13Error codeThe variable frequency Check the data communication cable between the
- F13-20Error codeElectrical window (KL15).
- F014Error codeCommand execution failure for unknown reason
- F14Error codeOver-current on the drive or Step 1: Check to make sure the washer cylinder turns
- F14-05Error codeHeating control (KL15).
- F015Error codeData conversion error
- F15Error code
- F15-20Error codeHeating fan motor (KL15).
- F016Error codeThe scanner is not available to communicate with a 1771 rack adapter
- F16Error codeThe temperature sensor Step 1: Make sure the cooling fi ns on the VFD heatsink
- F017Error codeThe adapter is no available to communicate with the module
- F018Error codeThe 1771 module response was not valid
- F019Error codeDuplicate label
- F025Error codeIndex markers are not continu Check linearisation table Bit 2 of Byte 0 … 5
- F036Error codeFailed or interrupted software Repeat software update Bit 3 of Byte 0 … 5
- F040Error codeHardware defect Exchanging the electronics Bit 4 of Byte 0 … 5
- F080Error codeGeneral software error Disconnect operating voltage Bit 5 of Byte 0 … 5
- F101Error codeThe high-pressure switch (HPS) Discharge pressure regulation valve is defective.
- F109Error codeLow pressure lowers abnormally Liquid solenoid valve coil is broken.
- F111Error codeHigh-pressure switch (HPS) High-pressure switch lead wire is broken.
- F113Error codeEMC interference Remove EMC influences Bit 12 of Byte 0 … 5
- F125Error codeTemperature of the electronics Check ambient temperature Bit 7 of Byte 0 … 5