Carrier Aquasnap All models error codes
Codes
- F415Error codeRated Motor Current
- F417Error codeRated Motor Speed
- FC-5Error codeFan Contactor (070-150)
- FC-6Error codeFan Contactor (080-150)
- FM2Error codeFan Board/Channel
- FM3Error codeFan Panosu/Kanalı
- FM4Error codeFan Panosu/Kanalı
- FM7Error codeFan Board/Channel
- FM8Error codeFan Board/Channel
- FM11Error codeFan Board/Channel
- hes57Error codeFeedback or speed signal lost. Drive will operate at 57 Hz until reset or loss of start command. Resetting requires cycling start command (or power)
- HR1Error code
- ite11Error codeAçıklama
- K1Error codeEnergize Compressor A1 (010-030) Energize Compressor A1 and Condenser Fan Contac- tor 3 (055,060)
- K3Error codeEnergize Chilled Water Pump 1 Output
- K4Error codeEnergize Minimum Load Valve
- K5Error codeWater Valve Open
- K6Error codeWater Valve Close
- K7Error codeLiquid Line Solenoid Valve
- K8Error codeCooler/Pump Heater
- K9Error codeChilled Water Pump
- K10Error codeCondenser Fan/Pump
- K11Error codeAlarm Relay
- L2Error codeCondenseur Entrée d’eau Sortie d’eau réchauffée Liquide + Gaz Liquide
- M10Error codeCondensing module, casing- structure, electrical box fixing, plate heat exchanger and pump
- MD14Error codeOFF/ON
- MD17Error codeOFF/ON
- MD18Error codeOFF/ON
- MD20Error codeOFF/ON
- MD24Error codeOFF/ON
- O1Error codeLoss of communication with Free Cooling Board
- O2Error codeLoss of communication with Electrical Heaters Board
- O3Error codeLoss of communication with Energy Management NRCP2 Board
- O4Error codeLoss of communication with Heat Reclaim Board
- P-05Error codeCircuit A Low Suction Temperature
- P-06Error codeCircuit B Low Suction Temperature
- P-07Error codeCircuit C Low Suction Temperature
- P-14Error codeCooler Interlock Failure
- P-15Error codeCondenser Flow Switch Failure
- P-16Error codeCompressor A1 Not Started or Pressure Increase not established
- P-17Error codeCompressor A2 Not Started or Pressure Increase not established
- P-18Error codeCompressor A3 Not Started or Pressure Increase not established
- P-19Error codeCompressor A4 Not Started or Pressure Increase not established
- P-20Error codeCompressor B1 Not Started or Pressure Increase not established
- P01Error codeLine Voltage: 01 = low line, 02 = high line
- P1Error codeUNIT RUN HOUR AND START Machine Operating Hours Machine Starts Water Pump 1 Run Hours Water Pump 2 Run Hours Heat Reclaim Pump Hours
- P118Error codeHigh Discharge Gas Temperature
- P200Error codeCooler Flow/Interlock Contacts Failed to Close at Start-Up
- P201Error codeCooler Flow/Interlock Contacts Opened During Normal Operation
- P0311Error codeRated Motor Speed