Xerox All models error codes
Codes
- J8-2Error codeDrum Cartridge EEPROM (Connector) failure… replace the Connector
- J516Error codeConnects the inside the Offset Motor Assembly
- J517Error codeConnects STK Motor Harness to the OCT PWB
- J518Error codeConnects the STK Motor Harness to the OCT Motor Assembly
- J521Error codeConnects the STK FLJM Harness to the Stack Full Sensor
- J523Error codeConnects the STK FLJM Harness to the OCT Sensor
- J605Error codeConnects the Elevation Motor to the 2000 Sheet Feeder PWB
- J608Error codeConnector’ inside the Elevation Motor
- J609Error codeConnects the 2000 Sheet Feeder FDM Harness to the Feed Motor
- J610Error codeConnects the 2000 Sheet Feeder NPS Harness to the No Paper Sensor
- J611Error codeConnects the 2000 Sheet Feeder FRDY Harness to the Paper Level Sensor
- J615Error codeConnects the 2000 Sheet Feeder TFM Harness to the Drive Assem- bly Motor
- own3Error code
- PER0Error codeSignal from the No Paper Sensor 0 (No Paper Sensor of the Tray 1). This signal is Low when the No Paper Sensor 0 is actuated
- PER1Error codeSignal from the No Paper Sensor 1 (No Paper Sensor of Tray 1). This signal is Low when the No Paper Sensor 1 is actuated
- PER2Error codeSignal from the No Paper Sensor 2 (No Paper Sensor of the Feeder 2). This signal is Low when the No Paper Sensor 2 is actuated
- PER3Error codeSignal from the No Paper Sensor 3 (No Paper Sensor of the Feeder 2). This signal is Low when the No Paper Sensor 3 is actuated
- ray1Error codeE2-11
- ray2Error codeE2-12
- ray3Error codeE2-13
- SNS2Error codeSignal from the Low Paper Sensor. Goes Low when paper is low in the Tray 2 (or 3)
- U1-1Error codeMain Motor clock signal fails during a copy job (a seized motor can do it)
- U4Error code1: A Fuser over-temperature condition is sensed
- U4-3Error codeFuser Overheat ** reset may be needed from Diagnostics (read below)
- U4-4Error codeFuser Overheat** reset may be needed from Diagnostics (read below)
- U4-6Error codeFuser Overheat** reset may be needed from Diagnostics (read below)
- U5Error codeFan Fail
- U5-2Error codeSorter Transport Motor problem detected (no clock signal from the motor…
- U6-4Error codeMemory Read/ Write failure (can relate to the Drum Ctg. Connector)
- U7-5Error codeSorter Communication problem
- VL1Error codeLaser power control signal that determines (or adjusts) the current flowing through the Laser Diode (analog signal)
- VL2Error codeLaser power control signal that determines (or adjusts) the current flowing through the Laser Diode (analog signal)