Sodeca çatı fanı All models error codes
Codes
- 1Error code
- 2Error codeAll
- 3Error codeThree-phase asynchronous motors. 400 V three-phase power
- 7Error code
- 8Error codeThis bit is set if motor current > P-08
- 9Error code
- 10Error code
- 11Error codeThis bit is set if control PCB temperature over 80°C
- 13Error codeThis bit is set when motor is in reverse rotation (negative speed)
- 115Error code230V Three-phase asynchronous motors. 115V Single-phase incoming supply
- E1Error codeIDU room sensor error
- E2Error codeODU condenser sensor error
- E3Error codeIDU evaporator sensor error
- E4Error code
- E5Error codeODU and IDU communication error
- E8Error codeCommunication fault between display board and PCB board
- F0Error codeODU fan motor error
- F1Error codeODU Module protection error
- F2Error codeODU PFC Protection Error
- F3Error codeCompressor start failure or out-of-step Error
- F4Error codeODU discharge sensor error
- F6Error codeODU room sensor error
- F8Error codeODU communication error between main PCB board and module board
- F9Error codeODU PCB EE error
- InError codeline extract fans for rectangular ducts with a 40 mm thick acoustic casing to reduce noise and EC Technology motor
- P-01Error codeMaximum output frequency or motor speed limit - Hz or RPM. If P-10 >0, the value entered / displayed is in RPM
- P00-07Error codeApplied motor voltage (V)
- P00-08Error codeDC bus voltage (V)
- P00-09Error codeHeatsink temperature (˚C)
- P00-15Error codeDC bus voltage log (V)
- P00-16Error codeHeatsink temperature log (˚C)
- P00-17Error codeMotor current log (A)
- P00-19Error codeInternal drive temperature log (˚C)
- P00-20Error codeInternal drive temperature (˚C)
- P00-27Error codeTotal run time of drive fans (Hours)
- P00-31Error codeMotor current Id / Iq
- P00-33Error codeCritical fault counter - O-I
- P00-34Error codeCritical fault counter - O-Volts
- P00-35Error codeCritical fault counter - U-Volts
- P00-36Error codeCritical fault counter - O-temp (h/sink)
- P00-37Error codeCritical fault counter - b O-I (chopper)
- P00-38Error codeCritical fault counter - O-hEAt (control)
- P00-39Error codeModbus comms error counter
- P00-40Error codeCANbus comms error counter
- P00-41Error codeI/O processor comms errors
- P00-42Error codePower stage uC comms errors
- P00-44Error codePhase U current offset & ref
- P00-45Error codePhase V current offset & ref
- P00-46Error codePhase W current offset & ref
- P00-50Error codeBootloader and motor control