Oki atm cihazı All models error codes
Codes
- On072Error codeI/F error between PU and CU
- On073Error codeDetection of abnormal condition during image data expansion
- On074Error codeDetection of abnormal condition during image data expansion
- ON075Error codeVideo error. An error was detected in expanding image data
- ON077Error codeVIC Illegal Decomp Error
- ON126Error codeSensor Dewed Error
- On190Error codeSystem memory overflow
- On203Error codeCU program error (not occur in normal operation)
- On207Error codeCU program error (not occur in normal operation)
- ON209Error codeCustom Media Type table downloading failed
- On213Error codeCU program error (not occur in normal operation)
- On250Error codeSecure File Erasing Error
- On901Error codeShort circuit (901) or open circuit (902) with the belt thermistor was detected
- On903Error codeThe belt thermistor detected abnormal temperature. 903: too high 904: too low
- ON923Error codeThe image drum does not revolve properly. Does the error display is provided again by turning off and on the MFP?
- ON933Error codeTray-2 CPU clock frequency error
- ON941Error codeA PU error was detected.
- per480Error code1) Check if the stacker is full. 2) Check if the Stacker Full Sensor activator is normal
- rum340Error code1) Is an Error message displayed? 2) Is the image drum properly mounted? 3) Does the Error take place again?
- ser320Error code1) Is an Error message displayed? 2) Is the fuser unit mounted properly? 3) Does the Error take place again?
- T1Error codeMAIN MOTOR driving
- T2Error codeT2 HOP LF FED _ _
- to495Error code1) Is an Error message displayed? 2) Is this immediately after the fuser unit was replaced?
- ver323Error code1) Has any abnormal substance get mixed in with the sensor? 2) Can the paper thickness detection be reset and restored by opening/closing the tray? 3) Is operation restored by turning OFF/ON the power?
- ver324Error code1) Has any abnormal substance get mixed in with the sensor? 2) Can the paper thickness detection be reset and restored by opening/closing the tray? 3) Is operation restored by turning OFF/ON the power?
- ver325Error code1) Is there any abnormal media mixed in? 2) Has the media been fed as overlapped sheets?
- ver326Error codeIs there any abnormal media mixed in?
- ver400Error code1) Is the paper a custom size? 2) Is the paper a standard size?
- zed001Error codeASP PCB KeyChip un- mounted or KeyChip Error is detected
- zed002Error codeThe ASP PCB HDD is not a standard (official) product
- zed003Error codeThe ASP PCB HDD program does not match the destina- tion
- zed004Error codeThe ASP PCB EEPROM unmounted or EEPROM Error is detected