Veichi servo-manual error codes
Codes
- BF4Error codeHardware over-current
- C10Error codeOut of control alarm
- C90Error codeEncoder communication failure: line-broken
- C91Error codeAbnormal encoder communication position data acceleration
- CA0Error codeAbnormal encoder parameters
- D00Error codeExcessive position deviation
- D02Error codeExcessive position deviation alarm caused by speed limit during servo ON
- Fn000Error codeDisplay alarm record
- Fn001Error codeClear alarm record
- Fn103Error codeCurrent offset automatic adjustment
- Fn104Error codeCurrent offset manual adjustment
- L3Error codeelay Drive Voltage Temp sampling sa
- Pn101Error code！ The command smart setting starts with the current speed loop gain (Pn101) as a reference. If vibration occurs at the start of the adjustment, correct adjustment Cautions cannot be performed. In this case, lower the speed loop gain (Pn101) until the vibration disappears, and then readjust
- Pn310Error codeAcceleration of the set speed from 0r/min to the rated speed (corresponding to the motor model). When the given speed is greater or less than the rated speed, the actual acceleration time is calculated in proportion
- Pn311Error codeAcceleration time of the set speed from 0r/min to the rated speed (corresponding to the motor model). When the given speed is greater or less than the rated speed, the actual acceleration time is calculated in proportion
- Pn605Error code0x04: Alarm clear