Mitsubishi lazer kesim makinesi All models error codes
Codes
- 10-4Error codeStorage temperature and humidity
- A400Error code1 to 3
- A702Error code0.1 to 30 s
- A804Error code9696: Clears the flash memory (no operation Write after writing during flash memory fault)
- C8Error codeCurrent output bias signal
- C9Error codeCurrent output bias current
- C10Error codeCurrent output gain signal
- C11Error codeCurrent output gain current
- DU08Error codeOutput terminal operation
- E022Error codePU communication data length
- E023Error codePU communication stop bit length
- E411Error code(0 to 5)
- E701Error code256
- een480Error codeInput voltage mode selection
- F820Error codeRated current (A)
- F840Error codeRated current (A)
- G122Error code1 to 5
- H0Error codeComputer NAK error
- H000BError codeOutput current peak value
- H000CError codeConverter output voltage peak value
- H1Error codeParity error
- H0002Error codeOutput current
- H2Error codeSum check error
- H002EError codeMotor temperature
- H0003Error codeOutput voltage
- H3Error codeProtocol error
- H003DError codeMotor thermal load factor
- H4Error codeFraming error
- H5Error codeOverrun error
- H005AError codeFault code (7)
- H005BError codeFault code (8)
- H0006Error codeMotor speed
- H0007Error codeMotor torque
- H0008Error codeConverter output voltage
- H08Error codeFunctions are diagnosed. (communication check only) A communication check can be made since the query message is sent and the query message is returned as it is as the return message (subfunction code H00 function). Subfunction code H00 (Return Query Data)
- H0012Error codeMotor excitation current
- H15Error codeNegative Acknowledge (Data error detected)
- H0018Error codeMotor load factor
- H0022Error codeMotor output
- H46Error codeThe number of registers that were successfully accessed by the previous communication is read. Queries by function codes H03 and H10 are supported. The number and start address of holding registers successfully accessed by the previous communication are returned. "0" is returned for both the number and start address for queries other than function code H03 and H10
- H0054Error codeFault code (1)
- H0055Error codeFault code (2)
- H0056Error codeFault code (3)
- H0057Error codeFault code (4)
- H0058Error codeFault code (5)
- H0059Error codeFault code (6)
- H0205Error codeMotor rotation (0-15bit)
- H0206Error codeMotor rotation (16-31bit)
- H301Error code1 to 10
- H500Error code0.1 to 400%