Markasi-Belli-Degil All models error codes
Codes
- HTError codee r o elb r e
- HUError code Commissioning
- HZError codeoutput output
- HZ-00Error codeP18.2.2.1 Sürücü 1
- I0Error codeÖlçülmüş toprak arıza akımı
- I1Error codeammeter value
- I2Error codeRTD obtained RAM
- I3Error codeFaz IL3'de ölçülen akım
- I004Error codeSpan failure 1- Span value from torque sensor is outside bounds.
- I4Error code0...2000% In
- I005Error codeOffset failure 1- Offset value from torque sensor is outside bounds.
- I5Error codeHesaplanan faz devamsızlık
- I6Error codeTespit edilen ışık (ark)
- I7Error code0 = tanımsız
- I8Error codeDI1 durumu 0,2
- I9Error codeDI2 durumu 0,2
- I10Error codeDI3 durumu 0,2
- I11Error codeDI4 durumu 0,2
- I12Error codeDI5 durumu 0,2
- I026Error codeTool maintenance alarm n1 1- The tool tightening counter has been reached.
- I027Error codeTool maintenance alarm n2 1- The tool tightening counter has been reached.
- I28Error code(<< (<< (<< (<< (<< (<<
- I038Error codeTool logs 1- Unexpected tool software exception.
- I046Error codeAbnormal battery current 1- Abnormal battery current consumption. Check the
- I063Error codeBattery pack removed 1- Battery pack removed from the tool detected.
- I065Error codeExternal start ignored 1- External start detected but ignored.
- I103Error codeInvalid rotary selector direction 1- Change the direction of the rotary selector.
- I205Error codeTorque settings 1- Invalid Torque setting: torque is greater than tool
- I206Error codeSpeed settings 1- Invalid speed setting: speed is greater than tool
- I210Error codeInvalid Pset selected 1- The selected Pset does not match the Pset selectable
- I211Error codeInvalid trigger configuration 1- The tool connected to the system is not equipped
- I224Error codeIGBT too hot 1- Power electronics too warm.
- I251Error codeNo Pset selected 1- No Pset selected.
- I270Error codeTime settings 1-Invalid Time setting|2-Check Pset settings with cor
- IAError code02: GEÇERSİZ VERİ ADRESİ
- IBError code3 successive coins are detected at Check inlet for blockage. If nothing is Clear blockage or replace harness
- ICError code= açma devresi boyunca akan akım, ~1,5 mA
- IDError codeThe received parameter data is invalid at the slave.
- IFError codeleaks request the
- IIError codeone is on) corresponding to the button S indicates the current status. S1 lights up, old password input, ending the key
- II-08Error codeBefore You Get Started
- ILError codeniatn g alp t
- IMError codeHandbuch originalen
- INError codeis appears and
- IN-03Error codeDrain valve connection Φ (outer)
- IN2Error codeR/W* dEF5 Trip history 5 (1) (p. 63) R
- IOError codeİyonizasyon sinyali
- IPError codeProtection rating
- ISError codedispensers when
- ITError codeonly). wrong