Kawasaki endüstriyel robot All models error codes
Codes
- E4534Error codeCC-LINK)Parameter setting error. XX
- E4536Error codeCC-LINK)Master board is abnormal. XX
- E4537Error codeCC-LINK)Initialization error on master board . XX
- E5005Error code(Spot weld)Weld schedule setting data is abnormal
- E5012Error codeCannot change the gun because offset data is abnormal
- E5019Error codeWeld fault signal is detected
- E5020Error codeRetract pos. monitor error
- E5021Error codeExtend pos. monitor error
- E5022Error codeCurrent gun retract position differs from a destination
- E5023Error codeWear is abnormal, cannot take measurement
- E5026Error code(Spot welding)RWC error. XX
- E5033Error codeCannot weld because of abnormal thickness
- E5039Error codeNo response from RWC communication I/F board
- E5043Error codeCommunication error in welder. (CodeXX)
- E5046Error codeWeld error has arisen
- E5049Error codeSerial number signal error
- E5052Error codeThe pressurizing power measurement value is abnormal
- E5053Error codeThe pressurizing power sensor is disconnected or it breaks down
- E5057Error codeInitialization failure in Initialization Weld board
- E5059Error codeWelder(DENGEN COMPANY) response error. (welder XX)
- E5062Error codeWelder(DENGEN COMPANY) data process error.(welder XX)
- E5063Error codeWeld error has arisen. (CodeXX)
- E5065Error codeWelder(DENGEN COMPANY) error has arisen. (welder XX)
- E5067Error codeMagnet control is abnormal.(welder XX)
- E5522Error code(Vision)System registered with abnormal data
- E5523Error code(Vision)Error in processing image(s)
- E5528Error code(Vision)Image capture error
- E5531Error code(Vision)Proto data abnormal, so initialized
- E5532Error code(Vision)Work detection failure
- E5533Error code(Vision)Initialization error. Code = XX
- E5534Error code(Vision)Vision system error
- E6011Error codePressure within enclosure is low
- E6018Error codePainting equipment control board error. (CodeXX)
- E6023Error code(Mutual-Wait)Communication error in Mutual-Wait
- E6025Error code(Conveyer synchronous communications)It is a conveyer position reception
- E6029Error code[Servo boardXX]Mismatch in internal pressure in safety circuit
- E6030Error code[Servo boardXX]Pressure within enclosure is low
- E6032Error code[Purge control board]Pressure within enclosure is low
- E6033Error codePainting equipment control process error. (CodeXX)
- E6034Error codeCartridge table rotate command is abnormal
- E6502Error codeArc failure
- E6504Error codeArc start failure
- E6505Error codeArc weld insulation defect
- E6516Error codeWire check failure
- E6520Error codeLaser sensor tracking value exceeded
- E6521Error codeBeyond Laser sensor tracking ability
- E6522Error codeLaser sensor cannot detect welding joint
- E6524Error codeError in data calculated using Laser sensor
- E6525Error codeCannot detect weld joint, Laser sensor tracking set already
- E6526Error codeNo response from Laser sensor controller