Hitachi kan ışınlama cihazı Tips give a special instruction that can error codes
Codes
- E6XError codeAn error has occurred in an expansion card or at its connecting terminals. Please refer to the manual for the expansion card for additional details
- E7XError codeExpansion card #2 connection error
- E23Error codeAn internal inverter error has occurred in commu- nications between the CPU and gate array IC
- E30Error codeWhen an instantaneous over-current condition occurs on any IGBT (output transistor) device, the inverter alarm trips. then it turns the outputs OFF in order to protect the circuitry
- H001Error codeAuto-tuning Setting
- H002Error codeMotor data selection, 1st motor
- H003Error codeMotor capacity, 1st motor
- H004Error codeMotor poles setting, 1st motor
- H005Error codeMotor proportional gain constant (factory set), range is 0.01 to 99
- H006Error codeMotor constant (factory set), range is 0 to 255
- H020Error codeMotor constant R1, 1st motor
- H021Error codeMotor constant R2, 1st motor
- H022Error codeMotor constant L, 1st motor
- H023Error codeMotor constant Io, 1st motor
- H024Error codeMotor constant J, 1st motor
- H030Error codeAuto-tuned constant R1, 1st motor
- H031Error codeAuto-tuned constant R2, 1st motor
- H032Error codeAuto-tuned constant L, 1st motor
- H033Error codeAuto-tuned constant Io, 1st motor
- H034Error codeAuto-tuned constant J, 1st motor
- H202Error codeMotor data selection, 2nd motor
- H205Error codeMotor proportional gain constant (factory set) range is 0 to 99
- H206Error codeMotor constant (factory set), range is 0 to 255
- H306Error codeMotor constant (factory set), range is 0 to 255
- L1Error codeDönüştürücü Dahili DC Bara İnvertörü ++ Redresör -
- O2Error codeAnalog input, voltage 2
- P001Error codeOperation mode on expansion card 1 error
- P002Error codeOperation mode on expansion card 2 error
- P025Error codeAllows for motor-mounted thermistor to calibrate output to motor temperature Two option codes: 00 Disable 01 Enable