Case IH All models error codes
Codes
- 1000Error codeTop Lock Solenoid Error
- 1002Error codeFront suspension not calibrated
- 1003Error codeSpeed Sensor Error
- 1006Error codeSlip control potentiometer signal too low
- 1007Error codeSlip control potentiometer signal too high
- 1008Error codeLift/Run Switch Malfunction
- 1009Error codeBoth external switches tripped at the same time
- 1010Error codeHeight limit potentiometer too low
- 1011Error codeHeight limit potentiometer signal too high
- 1012Error codeFall rate potentiometer signal too low
- 1013Error codeFall rate potentiometer signal too high
- 1014Error codeR/H load cell signal too weak
- 1015Error codeR/H load cell signal too high
- 1016Error codeL/H load cell signal too weak
- 1017Error codeL/H load cell signal too high
- 1018Error codeBoth load cells disconnected
- 1019Error codeLoad cell voltage too low
- 1020Error codeLoad cell voltage too high
- 1021Error codePosition/Thrust Control Potentiometer Too Low
- 1022Error codePosition/Thrust Control Potentiometer Too High
- 1023Error codeControl panel disabled
- 1024Error codePerform Hydraulic Lift Auto Calibration
- 1025Error codeMouse lift lever potentiometer signal too low
- 1026Error codeMouse lift lever potentiometer signal too high
- 1027Error codeMaximum Lift arm position potentiometer too low
- 1028Error codeMaximum Lift arm position potentiometer too high
- 1029Error codeHydraulic Control Valve Disabled
- 1030Error codeGround signal open circuit (not used)
- 1031Error codeChassis wiring harness disconnected
- 1032Error codeTraction load potentiometer shorted to +12V
- 1033Error codeTraction Load Potentiometer Open Circuit
- 1049Error codeWheel speed sensor circuit open
- 1053Error code5V link, shorted to +12V
- 1054Error codeReference voltage 5 V Short to ground
- 1057Error codeModule failure (not in use)
- 1059Error code5 volt reference open circuit (not used)
- 1063Error codeLower Solenoid Circuit Open
- 1064Error codeLift Solenoid Circuit Open
- 1065Error codeLower Solenoid Shorted
- 1066Error codeShort circuit of the lift solenoid
- 1067Error codeEDC hydraulic valve flow too low
- 1068Error codeHeight limit Calibration error
- 1400Error codeRear PTO Speed Short to VCC or Open Circuit
- 1401Error codeEngine speed sensor short to VCC or open circuit
- 1402Error codeRadar Speed Over Ground short to VCC or open circuit
- 1403Error codeFront PTO Speed Short to VCC or Open Circuit
- 1404Error codeEngine coolant temperature short to VCC or open circuit
- 1405Error codeFuel level sensor short to VCC or open circuit
- 1406Error codeAir brake pressure shorted to VCC or option set but sensor not connected
- 1407Error codeFront hitch position shorted to 12 or 5 volts