CNC All models error codes
Codes
- SV0458Error codeThe specified current loop differs from the actual current loop
- SV0460Error codeThe FSSB connection was discontinued. Probable causes are: 1) The FSSB connection cable was disconnected or broken. 2) The amplifier was turned off . 3) In the amplifier, the low-voltage alarm occurred
- SV0462Error codeThe correct data could not be received on a slave side because of the FSSB communication error
- SV0463Error codeThe correct data could not be received in the servo software side because of the FSSB communication error
- SV0466Error codeThe maximum current of an amplifier is different to that of a motor. Probable causes are: 1) The connection command for an amplifier is incorrect. 2) The parameter (No.2165) setting is incorrect
- SV0601Error codeExternal radiator cooling fan failure
- SV0602Error codeThe servo motor has overheated
- SV0603Error codeThe IPM (Intelligent Power Module) detected an overheat alarm
- SV0604Error codeThe communication between Servo amplifier and Power Supply (PS) is in error
- SV0605Error codePower Supply (PS) : The motor regenerative power is too much
- SV0606Error codePower Supply (PS) : External radiator cooling fan failure
- SV0646Error codeAn error occurred in the analog 1Vp-p output of the separate detector. The separate detector, cable, or separate detector interface unit may be failed
- SV1067Error codeAn FSSB configuration error occurred (detected by software). The connected amplifier type is incompatible with the FSSB setting value
- SV5134Error codeIn the initialization, the FSSB could not be in an open ready sate. The axis card is thought to be defective
- SV5136Error codeThe number of amplifier identified by the FSSB is insufficient than the number of control axes. Or, the setting of the number of axes or the amplifier connection is in error
- SV5137Error codeAn FSSB configuration error occurred. The connecting amplifier type is incompatible with the FSSB setting value
- TS5690Error codeMitsubishi Electric
- TS5691Error codeInitialization error
- WN03Error code
- WN11Error code
- WN59Error code
- WN60Error code
- WN61Error code
- WN62Error code
- WN64Error code
- WN65Error code
- WN66Error code