Case IH All models error codes
Codes
- 3115Error codeMain Relay Defect - INCREDIBLE
- 3116Error codeMain relay defect - SOURCE HIGH
- 3117Error codeECU Self-Test Shutdown Ways - IMPOSSIBLE
- 3118Error codeSensor Power Supply - NOT AVAILABLE
- 3119Error codeSensor power supply - NO SIGNAL
- 3120Error codeSensor Power Supply - ALL OTHER FAULTS
- 3121Error codePTO torque sensor open circuit
- 3122Error codeShort circuit of the PTO engine torque sensor
- 3123Error codePTO Torque not CAL error
- 3124Error codehand throttle potentiometer, high error 2
- 3125Error codeManual throttle potentiometer 2 Low error
- 3126Error codehand throttle potentiometer high error 1
- 3127Error codeManual Throttle Potentiometer 1 Low error
- 3128Error codeManual Throttle Potentiometer Differential error
- 3129Error codeManual Throttle Idle Switch High Error
- 3130Error codeHand Throttle Low Idle Switch Error
- 3131Error codeWays to disable self-test ECU (startup)
- 4001Error codeAux-stick signal (AUX1) out of range low
- 4002Error codeAuxiliary joystick signal (AUX1) out of range
- 4003Error codeSignal from remote rate potentiometer 1 (AUX 1)
- 4005Error codeAux-stick signal (AUX2) out of range low
- 4006Error codeAuxiliary joystick signal (AUX2) out of high range
- 4007Error codeSignal from remote rate potentiometer 2 (AUX 2)
- 4008Error codeSignal from Remote Valve 2 Timer Pot 1 Out of Range
- 4009Error codeAux-stick signal (AUX3) out of range low
- 4010Error codeAuxiliary joystick signal (AUX3) out of range
- 4011Error codeSignal from remote rate potentiometer 3 (AUX 3) is out of range
- 4015Error codeSignal from remote rate potentiometer 4 (AUX 4) is out of range
- 4016Error codeRemote valve signal Timer 1 potentiometer out of range
- 4040Error codeToo low supply voltage
- 4041Error codeSupply voltage too high
- 4042Error codeArmrest module (ARU) CAN ‘Bus off’
- 4043Error codeController failure (case check)
- 4044Error codeController failure (flash)
- 4045Error codeController failure (data memory)
- 4100Error codeRemote No.1 Received no control message
- 4101Error codeRemote No.1 Control Message invalid
- 4102Error codeRemote No.1 EEPROM Error
- 4103Error codeRemote No.1 switched to failover mode
- 4104Error codeRemote Control No.1 Powered
- 4105Error codeRemote Control No. 1 Surge Protection
- 4106Error codeRemote No.1 Spool down
- 4108Error codeRemote No.1 Float position not reached
- 4109Error codeRemote No.1 Manual control
- 4110Error codeRemote No.1 Driver defective
- 4111Error codeNo.1 remote potentiometer defective
- 4112Error codeRemote No.1 Failed to set neutral
- 4113Error codeRemote control spool #1 not in neutral when key is turned on
- 4114Error codeRemote No.2 No control message received
- 4115Error codeRemote No.2 Control Message unreliable