Case IH All models error codes
Codes
- 8099Error codeFront PTO option not included
- 9001Error codeFront HPL (High Pressure Lift) Potentiometer open circuit
- 9002Error codeFront HPL (High Pressure Lift) Short circuit of the potentiometer
- ANS101Error codeLow transmission clutch pressure detected. Slips or fails to engage
- AUX157Error codeHigh-pressure common rail leak or sensor fault. Engine may enter Limp Mode
- CHError codeOil Temperature Above 105 Degrees Centigrade
- CLError codeOil Temperature Between 10 and 19 Degrees Centigrade
- ENG111Error codeController internal failure. Check main power relay and ground straps
- ENG115Error codeCrankshaft or camshaft speed signal lost. Engine cranks but won't start
- ENG143Error codeCritically low oil pressure. Stop engine immediately
- HYD204Error codeHitch position sensor out of range. 3-point hitch may not move
- U01Error codeFront Axle Potentiometer Open Circuit
- U03Error codeFront Axle Potentiometer Short Circuit Auto Calibration Procedure Will Not Work
- U19Error codeOil Temperature Below 10 Degrees Centigrade
- U50Error codePTO Twist Sensor Not Calibrated
- U56Error codeEngine Torque/RPM Sensor Open Circuit
- U57Error codeEngine Torque/RPM Sensor Short To Ground
- U58Error codePTO Twist Sensor Open Circuit
- U59Error codePTO Twist Sensor Short To Ground
- U86Error codeMedium/Reverse Range Synchronizer Neutral Error
- U87Error codeLow/High Range Synchronizer Neutral Error