Baxter All models error codes
Codes
- 32Error codeSystem Error 32
- 33Error codeSystem Error 33
- AB01Error codeDuring antibolus motor has exceeded the step count limit
- AB02Error codeDuring antibolus pusher position travel has exceeded the limit
- AB03Error codeAntibolus duration has exceeded the limit
- AL01Error codeAlarm manager software module has failed
- B0691Error codeDirection and Drive Motor Module (DDMM) (Daughter Board)
- B0696Error codeRetainer Bracket, Motor
- B6210Error codeSyringe size sensor
- B6660Error codeSecure sensors unit B6660032
- B8703Error codeSyringe barrel sensor cover
- BAR01Error codeBarrel sensor is damaged
- BN0360Error codeOperator’s Manual Flo-Gard GSP Syringe Infusion Pump
- BS0360Error codeService Manual Flo-Gard GSP Syringe Infusion Pump
- BT01Error codeCommunications with the battery fuel gauge has failed
- BT02Error codeThe battery cell voltage is low (less than 1.05V per cell)
- BT03Error codeThe battery cell voltage is high (greater than 1.75V per cell)
- BT04Error codeThe battery temperature is high (greater than 60°C)
- BT05Error codeThe battery charging current is high (greater than 1.5A)
- BT06Error codeThe battery discharging current is high (greater than 1.5A)
- BT07Error codeThe battery charging current is low (less than 50mA)
- BT09Error codeThe battery is discharging whilst the pump is on the mains
- C5Error codeRetainer Bracket, Motor
- C7Error codeDirection and Drive Motor Module (DDMM) (Daughter Board)
- CN701Error codePANEL LOCK switch is not accepted
- CN851Error codeDOOR OPEN alarm occurs while door is closed, or does not occur when door is opened
- D4Error codePusher lever sensor (D5)
- EE03Error codeExternal EEPROM software module has failed
- EV01Error codeSoftware Event module has failed
- F3Error codeF3 on UIM PCB is blown
- ID01Error codeIncorrect drug name or pump ID in EEPROM
- IF01Error codePump software not compatible with hardware revision
- LCD01Error codeLCD display software module has failed
- LCD02Error codeSoftware graph plotting on display module has failed
- LED01Error codeLEDs control software module has failed
- M0Error codepump status is corrupt at set status() _ _
- M1Error codepump status is corrupt at clear status() _ _
- M8Error codeEEPROM read after write error in reset event log() _ _
- M9Error codeEEPROM read after write error in reset event log() _ _
- N0Error codeEEPROM read after write error in log event() _
- N1Error codeEEPROM read after write error in log event() _
- N2Error codeEEPROM read after write error in reset syserr log() _ _
- N3Error codeEEPROM read after write error in reset syserr log() _ _
- N4Error codeEEPROM read after write error in log syserr() _
- N5Error codeEEPROM read after write error in log syserr() _
- N6Error codechecksum error on get next event() _ _
- N8Error codechecksum error on log syserr() _
- N9Error codechecksum error on get next syserr() _ _
- nce804Error codeNuisance 804:34 failure code correction
- of0Error codeMeasuring pumped solution in volume delivery accuracy tests