York havalandırma All models error codes
Codes
- and108Error codeNOTE: For all hot water coils the entering water tempera- ture should not exceed 200°F. The hot water coil is located downstream of the supply air fan and just above the supply air opening in the bottom of the unit. Refer to Tables 58 through 66 and Figures 36 through 49 for flow rate and capacity
- BLE36Error code5 HP Motor & 793 RPM Drive 20 HP Motor & 814 RPM Drive RPM Req’d Browning %RPM Req’d Browning CFM PD 2b5v & CFM PD 2b5v __ __ 83 5 50 85 5.8 58 87 5.2 52 88 6 60 90 5.4 54 91 6.2 62 95 5.7 57 94 6.4 64 97 5.8 58 97 6.6 66 100 6 60 100 6.8 68 103 6.2 62 103 7 70 107 6.4 64 109 7.4 74 110 6.6 66 118 8 80 113 6.8 68 126 8.6 86 117 7 70 - - - 123 7.4 74 - - -
- CF1Error codeCond Fan Bank 1, 2
- CF2Error codeCondenser Fan contactor output (Relay Contacts - 24 VAC/120 VAC)
- Co2Error codeAnalog input of the outdoor CO2 sensor
- for80Error codeDO NOT use hot water coils as steam coils under any circumstances. All piping, control valves, and wiring that is field installed must be properly insulated and conform to all local and national codes
- GV1Error codeGas Valve input (24 VAC sense) For Burner section 1
- GV1-3Error codeMonitors gas valve actuation call
- GV2Error codeGas Valve input (24 VAC sense) For Burner section 2
- GV3Error codeGas Valve input (24 VAC sense) For Burner section 3
- J6-1Error codeINPUT RETURN FAN PRESS (341)
- J6-6Error codeCOM RETURN FAN PRESS (342)
- J7-1Error codeINPUT ZONE TEMP SENSOR (363)
- J7-2Error codeINPUT FLEXSYS SLAB SENSOR (366)
- J7-6Error codeSHIELD ZONE TEMP SENSOR (364)
- J7-7Error codeSHIELD FLEXSYS SLAB SENSOR (367)
- J7-11Error codeREF ZONE TEMP SENSOR 5VDC (362)
- J7-12Error codeREF FLEXSYS SLAB SENSOR 5VDC (365)
- P1Error codeEstablishes the communication baud rate for port 1
- P2Error codeEstablishes the communication baud rate for port 2
- P3Error codeEstablishes the communication baud rate for port 3
- P4Error codeEstablishes the communication baud rate for port 4
- ULT10Error codeDisplays the active fault #10 in Table 66 and Table 67