Xinje VFD-manual VFD-manual error codes
Codes
- P7-56Error codeOver voltage stall protection voltage
- P7-67Error codeSelection of instantaneous stop non-stop function
- P7-68Error codePause judgement voltage of transient stop action
- P7-69Error codeJudgment time of instantaneous stop non-stop voltage rising
- P7-70Error codeJudgement voltage of instantaneous stop non-stop action
- P8Error codeBit25
- P8-02Error codeParameter initialization
- P8-08Error codeBit2
- P8-09Error codeBit1
- P8-13Error codeVFD type display
- P8-19Error codeInverter module radiator temperature
- P9-00Error codecommunication protocol selection
- P9-02Error codeCommunication baud rate
- P9-04Error codeCommunication timeout
- PA-01Error codeMotor rated power / voltage / current / frequency / speed
- PA-02Error codeFeedback channel selection
- PA-06Error codeEquivalent stator resistance, inductance and rotor inductance of the motor
- PC-20Error codeFrequency detection value (FDT2 voltage level)
- PC-21Error codeFrequency detection hysteresis value (FDT2 voltage level)
- PC-34Error codeCurrent reached detection value 1
- PC-35Error codeCurrent reached detection 1 range
- PC-36Error codeCurrent reached detection value 2
- PC-37Error codeCurrent reached detection 2 range
- PC-38Error codeZero current detection value
- PC-39Error codeZero current detection delay time
- PC-40Error codeSoftware overcurrent point
- PC-42Error codeAI1 input voltage lower limit
- PC-43Error codeAI1 input voltage upper limit
- PC-44Error codeOver voltage point
- PC-45Error codeUnder voltage point
- PC-47Error codeModule temperature reached
- PC-48Error codeFan control
- PC-61Error codeWave by wave current limiting enable
- PC-62Error codeCurrent detection compensation
- PC-65Error codeBus voltage reached value
- PC-66Error codeThe bus voltage reached hysteresis value
- PC-68Error codeThe carrier frequency is adjusted with temperature
- PF-01Error codeUpper limit source of driver torque
- PF-03Error codeTorque control forward direction max frequency source
- PF-05Error codeTorque control reverse direction max frequency source
- U0Error codemotor speed 1
- U0-02Error codeBus voltage (V)
- U0-03Error codeOutput current (A)
- U0-04Error codeOutput voltage (V)
- U0-05Error codeOutput torque (%) Percentage output value of motor rated torque
- U0-09Error codeAI1 voltage (V)/current(mA)
- U0-10Error codeAI2 voltage (V)/current (mA)
- U0-25Error codeCommunication setting
- U0-26Error codeAI1 voltage/current before calibration
- U0-27Error codeAI2 voltage/current before calibration