Xinje VFD-manual error codes
Codes
- PC-38Error codeZero current detection value
- PC-39Error codeZero current detection delay time
- PC-40Error codeSoftware overcurrent point
- PC-42Error codeAI1 input voltage lower limit
- PC-43Error codeAI1 input voltage upper limit
- PC-47Error codeModule temperature arrival
- PC-48Error codeFan control
- PC-61Error codeWave by wave current limiting enable
- PC-65Error codeBus voltage arrival value
- PC-66Error codeThe bus voltage arrival hysteresis value
- PC-68Error codeCarrier frequency adjusted with temperature
- PC-72Error codeExternal linear speed given source
- PF-01Error codeUpper limit source of driver torque
- PF-03Error codeTorque control forward maximum frequency source
- PF-05Error codeTorque control reverse maximum frequency source
- U0-02Error codeBus voltage (V)
- U0-03Error codeOutput current (A)
- U0-04Error codeOutput voltage (V)
- U0-05Error codeOutput torque (%) percentage output value of motor rated torque
- U0-09Error codeAI1 voltage (V)/current(mA)
- U0-10Error codeAI2 voltage (V)/current (mA)
- U0-25Error codeCommunication setting value
- U0-26Error codeAI1 voltage/current before calibration
- U0-27Error codeAI2 voltage/current before calibration
- U0-33Error codePresent fault
- U0-34Error codeFault information
- U0-44Error codeVF separate target voltage
- U0-45Error codeVF separate output voltage
- U0-47Error codeMotor serial number
- U0-66Error codeMotor speed
- U0-70Error codeCommunication feedback motor speed 1
- U0-71Error codeCommunication feedback motor speed 2
- U0-72Error codeSpecial current display for communication card
- U0-73Error codeCommunication card error status
- U0-74Error codeMotor actual output torque
- U0-75Error codeFault code
- U0-76Error codeBit11