Woodward generator kontrol paneli All models error codes
Codes
- 2-14Error codeThe module detected that communications to one of the DSENet® expansion modules had been lost
- 2-26Error codeThe module received a fault condition from the engine ECU alerting about the DEF level
- 2-27Error codeThe module detected that a battery charger connected by DSENet® had a Charger Failure alarm
- 2-32Error codeThe module detected that the generator output kvar had fallen below the Loss of Excitation Pre-Alarm Trip level
- 2-46Error codeThe module detected that circuit to the engine oil pressure sensor had become open circuit
- 2-50Error codeThe module detected that the generator output current had risen above the Generator Over Current Trip
- 2-51Error codeThe module detected that the generator earth fault current had risen above the Earth Fault Trip Level for the duration of the IDMT function
- 2-63Error codeThe module received a fault condition from the engine ECU alerting about the SCR Inducement
- 2-71Error codeThe module detected that circuit to the engine fuel level sensor had become open circuit
- 056-010Error codeOver Current Protection
- 056-019Error codeEarth Fault Protection
- 056-076Error codeReading DSEGencomm Alarms
- 056-092Error codeBest Practices for Wiring Restive Sensors
- 057-220Error codeOptions for Communications with DSE Controllers
- C37Error codeContinued… 15 - Speed or frequency matching device.
- DM1Error codeDiagnostic Message 1 A DTC that is currently active on the engine ECU
- EEE37Error codeThe module detected that its DC supply voltage had risen above the Plant Battery Overvolts Warning Trip level for the configured delay timer
- FF01Error codeRequested Generator Excitation Field Current (FCR Setpoint)
- ID0Error codeNOTE: Due to module configuration the alarm message that appears on the display may be different. For further details of module configuration, refer to DSE Publication: 057-238 DSE8610 MKII Configuration Suite PC Software Manual
- ID1Error codeThe module detected that an analogue input value of a DSE2130 had risen above the Flexible Sensor High Pre-Alarm Trip level
- or51NError codeThe module received an amber fault condition from the engine ECU
- RS485Error codeRS485 iletişim anormal
- to3Error codeThe module detected that a battery charger connected by DSENet® had issued a Common Warning Alarm
- to4Error codeNOTE: Due to module configuration the alarm message that appears on the display may be different. For further details of module configuration, refer to DSE Publication: 057-238 DSE8610 MKII Configuration Suite PC Software Manual
- V1Error codeGenerator L1 (U) Voltage Sensing
- V2Error codeBus L1 (R) Voltage Sensing