Ventacity filtre All models error codes
Codes
- F0Error codeNormal operation of the VFD: VFD display shows operating frequency fi rst very quickly then changes to F0.0 at time power is returned. This will stay displayed until the VFD receives a command from main control PCB. (Pushing start button) A CE-10 fault will display at drive if improper communication between PCB and VFD has occurred. Note: Resetting a fault code on front of washer: Turn the power off to machine (machine will need to remain off for up to three minutes ). SOFT RESET : is accomplished by pushing the white button located on the Main controller PCB board and simultaneously turning power on to machine. This will reset main controller to factory default settings. Please record any modifi ed information that has been inserted in memory before attempting to Soft Reset the PCB. CE5, CE7 and CE8-Reserved by DELTA
- F1Error codeThe door failed to close and lock or The door failed to remain locked during the cycle
- F2Error codeThe washer tub does not fi ll with water within 7 minutes. The wash cycle will continue. The F 2 will fl ash three times, then wait for 30 seconds. The error will clear at the end of the cycle
- F3Error codeMemory error in controller. The memory checksum is wrong
- F4Error codeWasher controller communication error
- F5Error codePressure Switch error (only OPL) - when the high level sensor indicates full but the lower one indicates empty. The wash cycle will continue. The F 5 will fl ash three times, then wait for 30 seconds. The error will clear at the end of the cycle
- F6Error codeWrong washer size for drive type
- F22Error codeWarning codes F22 - F28: These codes indicate that a component (VFD, relay PCB, injection relay PCB, water valve) has been replaced, added, or removed and you will need to soft reset the PCB controller board to reset the main controller to operate properly
- F27Error codeInjection relay PCB has been added to machine or loose connection
- F28Error codeFault#