Veichi All models error codes
Codes
- Pn005Error codeServo occurrence type 2 alarm stop method selection
- Pn7AError codeBlocked-rotor overload protection time percentage
- Pn009Error code
- Pn79AError code
- Pn100Error codeMoment of inertia ratio = load inertia of motor shaft conversion / rotor moment of inertia of servo motor *100%
- Pn185Error codeSet the sensitivity of the detected vibration. The smaller the setting value is, the more sensitive it is. If the setting is too small, the vibration may be detected by mistake during normal operation. Note: The detection sensitivity of the vibration alarm and vibration alarm may differ depending on the state of the machine being used
- Pn186Error codeSet the threshold for vibration detection. The smaller the setting is, the easier it is to detect the vibration. If the setting is too small, the vibration may be detected by mistake during normal operation. Note: The vibration detection values of vibration alarm and vibration warnings may differ according to the condition of the used machine
- Pn252Error codeThe deviation coefficient between the load of the motor with one full closed-loop rotation
- Pn257Error codeSetting of excessive deviation between motor and load
- Pn702Error codeThe number of rotations of the motor during the inertia identification
- Pn731Error code
- Pn732Error code
- Pn792Error code
- RS485Error codeRS485 communication writes the value to the 0x3000 address to get the given frequency value
- SC1Error codeHızlanma sırasında sistem hatası
- SC2Error codeYavaşlama sırasında sistem hatası
- SC3Error codeSabit hızda sistem hatası
- SC4Error codeÇalışmazken sistem hatası
- T2Error code
- TE1Error code●Start static detection while motor is
- TE2Error code● Detection overtime
- U1Error code485 Communication
- U4Error codeOp-Amp
- U5Error codeOctal Driver
- U7Error codeComparator
- U9Error codeComparator
- U11Error codeLogic Chip
- U16Error code485 Communication