Tokyo Keiki gemi navigasyon sistemi All models error codes
Codes
- 1Parameter2. Input circuit (1st circuit) Case : Gyro compass TG-8000 * Caution ! Set the serial signal TG-8000 side IEC-61162-1 ed.2 （4800bps） (Refer the Jumper setting Gyro compass TG-8000 side.) Serial signal input Silk （TG6） terminal board NRXH Serial Signal RS-422 （H) ： TG-8000 *TX+ Terminal Connection NRXL Serial Signal RS-422 （L) ： TG-8000 *TX- Terminal Connection NRXS Serial Signal RS-422 （Signal GND) ： TG-8000 *TSC Terminal Connection ① Setting when receives by Conversion IC Jumper Name Setting E20 3-4 short E21 3-4 short E22 3-4 short E1 3-4 short ② Setting when receives by current loop Jumper Name Setting E20 1-2 short E21 1-2 short E22 1-2 short E1 1-2 short
- 5-20Error codeStep motor Ass'y
- 5-21Error codeStep motor
- 5-53Error codeStep motor
- 5-62Error codeStep motor
- dle-1Error codedetails
- E-1Error codeWhen the main power (AC power source) is lost
- E-2Error codePower supply unit in the control box becomes over current
- E-3Error codeInverter in the master compass becomes over current
- E-5Error codeGyro rotor current is abnormal
- E-6Error codeRotor tilting angle is abnormal
- E-7Error codeHorizontal servo loop is abnormal
- E-8Error codeZero cross azimuth angle sensor is abnormal
- E-9Error codeMemory is abnormal
- E-AError codeCommunication error (MCC→SCC)
- E-cError codeWhen GPS system is stopped or serial signal from GPS is cut.(timeout is 15 sec.)
- E-dError codeGPS latitude data abnormal.(timeout is 17 sec.)
- E-EError codeWhen MAG/EHS system is stopped or serial signal from MAG/EHS is cut.(timeout is 15 sec.)
- E-FError codeEHS data abnormal.(timeout is 17 sec.)
- E-GError codeWhen compensation of the bearing by the encorder signal is not completed
- E-LError codeWhen EXT. sensor system is stopped or serial signal from EXT. sensor is cut.(timeout is 15 sec.)
- E-nError codeEXT. sensor data abnormal.(timeout is 17 sec.) Bearing field abnormality
- E-PError codeWhen LOG(serial) system is stopped or serial signal from LOG(serial) is cut.(timeout is 15 sec.)
- E-rError codeE5V(power supply of serial signal) is lost
- E-UError codeLOG(serial) data abnormal.(timeout is 17 sec.)