Thermo Fisher All models error codes
Codes
- and20Error code3x2,2 > 10M
- E-08Error codePrüfsummenfehler E-PROM
- E-12Error codePrüfsummenfehler NV RAM
- E-13Error codePrüfsummen- fehler NV RAM
- E-14Error codeKältekreislauf defekt
- E-15Error codeFühlerbruch
- E-16Error codeFühlerkurzschluß
- E-17Error code
- E-18Error codeUrsache
- E-19Error codeStörung bei Erkennung
- E-21Error codeRotorerkennung gestört
- E-22Error codeDrehzahlmessung gestört
- E-24Error codeDeckelschloss blockiert
- E-27Error code
- E-28Error codeUrsache
- E-30Error codeSteuerspannung eingebrochen
- E-31Error codeCAUTION: Motor may be hot!
- E-32Error codeÜbertemp.Schutz -Elektronik >90°C
- E-33Error codeÜberdruck Kälteanlage
- E-34Error code„E-35“ message
- E-35Error code„E-36“ message
- E-36Error code
- E-39Error codeRemedy: Cycle power off/on. Replace the main board if the error persists
- E-40Error code
- E-41Error codeOffsetspannung Unwuchtsensor ist im unzulässigen Bereich
- E-44Error code
- E-45Error codeRemedy: After any error involving the speed signal or a power outage, the centrifuge
- E-46Error code“Lid” - Lid opened during spin Deceleration method: free coasting Remedy: The lid was opened during the run. Close the lid immediately! If this alarm comes up even though the lid is closed, check the lid lock micro switches and wires
- E-48Error codeSet value status unit error
- E-49Error codeUndefined error occurred Deceleration method: free coasting Remedy: Cycle power off/on. Replace the NV-RAM if the error persists
- E-50Error codeTemperature status unit error
- E-51Error codeNV-RAM status unit error Deceleration method: free coasting Remedy: Cycle power off/on. Replace the main board if the error persists
- E-52Error codeLid status unit error
- E-53Error codeSoftware primary and secondary mask reading error Deceleration method: braking Remedy: Cycle power off/on.
- E-54Error codeSoftware primary and secondary mask writing error
- E-61Error codeTrennung Motor
- E-62Error codeSet value error Deceleration method: free coasting Remedy: Cycle power off/on. Replace the main board and/or NV-RAM if the error persists
- E-70Error codeCLASS A trap Software break aufgetreten
- E-71Error codeReset durch Software
- E-100Error codeSet value error Deceleration method: free coasting Remedy: Cycle power off/on. Replace the main board if the error persists
- E-109Error codeRemedy: Cycle power off/on. Replace the main board and/or NV-RAM if the error
- E1Error codeClipTip™ Pipette system failure (E1-012)
- E02Error codeControl Probe Failure
- E03Error codeHeat Exchanger Probe Failure
- E04Error codePower Failure
- E05Error codeFailure to Reach Setpoint
- E06Error codeBUS Battery Failure
- E07Error codeSystem Battery Failure
- E09Error codeLost Communication Failure (BUS)
- E11Error codeAmbient Probe Failure