Rheem termosifon All models error codes
Codes
- 1Error codeIgnition failure
- 2Error codeFlame not detected
- 3Error codePressure switch stuck open
- 4Error codeHigh limit switch open (overheat)
- 5Error codeFlame sensed when off
- 6Error codePressure switch stuck closed
- 8Error codeBlower motor fault
- 10Error codeWeak flame signal
- 12Error codeLockout due to repeated failures
- 13Error codeLimit switch locked out
- 14Error codeIncorrect line voltage
- A055Error code4-16 DC Volts? Yes While water is flowing, and the unit is at tempting to ignite. Is the voltage No 4-10 DC volts? Yes Operate unit again. ! CAUTION: Hot water temperatures above 120 will scald. Return to original setting once test is complete
- A061Error codeIs the voltage No 12-18 DC Volts? Yes Test DC voltage between #1 wire (Yellow) & #4 wire (Blue) Is the voltage a No pulsating Replace blower motor. 4-10 DC volts? Yes Turn off gas and water to the water heater. IMPORTANT DO NOT cross any of the wires while performing these checks
- A065Error code4-16 DC Volts? Yes While water is flowing, and the unit is attempt ing to ignite. Is the voltage No 4-10 DC volts? Yes Operare unit again.
- A066Error code4-16 DC Volts? Yes While water is flowing, and the unit is attempt ing to ignite. Is the voltage No 4-10 DC volts? Yes Operate unit again.
- E3Error codeSensör arızası
- F01Error code
- F02Error codeSensör arızası
- F03Error code
- F04Error codeDüşük voltaj
- FO2Error codeFO2 (Sensör arıza)