Posiflex yazarkasa All models error codes
Codes
- 90-95Error codeThe XIO card has dropped off the communication link between other XIO cards and the ACB
- C1Error codeThis terminal is tied to the Ethernet port shield. Tie this terminal to a clean ground in order to improve noise immunity when using external communication peripherals
- C2Error codeThis is the signal common for the communication signals
- D15Error codeKorean Registration of Broadcasting and Communications Equipment Compliant with the following standards: Article 58-2 of Radio Waves Act, Clause 3
- FLT01Error codeControl Connection Update Fault
- FLT02Error code
- FLT03Error code
- FLT05Error codeClock Skew Fault
- FLT06Error codeLost Controller Connection Fault
- FLT07Error codeClock Sync Fault
- FLT09Error codeDuplicate IP Address Fault
- I1Error codeI1 Fault Q Full I2 Fault Q Full I3 Fault Q Full
- L1Error codehase Input Line Voltage Connection
- lex520Error codeReplacement fan for drive power module
- lex527Error codeReplacement power module for use with PowerFlex 527 drive. Includes: • Power Module • Power Module Front Cover • Power Terminal Guard • Heatsink Fan
- M10Error code
- M14Error codeInvalidSafeyFirmwareFault(2)
- M15Error code
- M21Error code
- M26Error code
- M28Error codeSafetyModuleCommunicationErrorFault(1)
- P1Error codeP1 Fault Q Full P2 Fault Q Full P3 Fault Q Full
- put380Error code200% hardware limit, 300% instantaneous fault
- R1Error codeThese are the Normally Open (N.O.), Common, and Normally Closed (N.C.) contacts for the programmable relay output. Note: These are general-purpose outputs and do not have the same functionality as system outputs when compared to chassis or remote I/O products. See the Logix 5000® Controllers General Instructions Reference Manual, publication 1756-RM003, for important information regarding execution conditions and action that is taken for the respective instructions used to control the digital outputs on the drive
- S01Error codeCPUWatchdogFault(1)
- S03Error codeSafeTorqueOffFault(2)
- S07Error codeMotor Thermal Overload Factory Limit Fault
- S08Error code
- S09Error codeGuardStopInputFault
- S10Error code
- S11Error code
- S13Error codeInverter Thermal Overload Factory Limit Fault
- S16Error code
- S23Error code
- S25Error code
- S29Error codeBus Regulator Thermal OverLoad Factory Limit Fault
- S34Error code
- S35Error codeBus Overvoltage Factory Limit Fault
- S41Error code
- S43Error code
- S54Error code
- S55Error code
- S56Error code
- S57Error code
- T1Error codeSwitch any two motor leads to change forward direction or change the or Phase Connection = Motion Polarity within Studio 5000 Logix Designer application > Axis Properties > Polarity category