Phoenix küvöz inkübatör All models error codes
Codes
- A010Error codeLower-level bus: Module error
- A014Error codeLower-level bus: Parameterization error on the device
- A020Error code
- A022Error codeLower-level bus: Multiple transmission errors
- A023Error codeLower-level bus: I/O data communication error
- A024Error codeLower-level bus: Management data communi- cation error
- A030Error codeLower-level bus: Configuration error
- A041Error codeLower-level bus: Hardware fault
- A042Error codeLower-level bus: Firmware error
- d1Error codeActual temperature from upper tank sensor
- d2Error codeActual temperature from lower tank sensor
- d5Error codeOutdoor Sensor
- d6Error codeActual Fan Speed divided by 10 (Example: If fan speed displayed is 410 x 10 = 4100 RPM actual fan speed)
- d7Error codeActual Ionization Current read from flame rectification probe
- d10Error codeActual status of bus communication - co = connected, nc = not connected
- E1Error codeDevice error or warning Indicates messages that apply to the entire device
- E2Error codeI/O error, channel error or warning (group message) Indicates messages that only apply to a single channel
- F00Error codeHigh temperature switch limit exceeded 194oF
- F01Error codeVent temperature limit exceeded
- F02Error codeInterrupted or shorted upper temperature sensor
- F03Error codeInterrupted or shorted lower temperature sensor
- F05Error codeUpper temp. sensor exceeds 194oF
- F06Error codesensor exceeds 194oF
- F09Error codeNo flame detected - Heater will make three attempts at ignition before the control goes into this lockout condition. Will reset in 1 hour
- F10Error codeLoss of flame signal - The heater will attempt to relight four times before the control goes into this condition. Will reset in 1 hour
- F11Error code