Panasonic nem alma cihazı All models error codes
Codes
- D1Error codeSpecify the device address storing the acquired status
- D2Error codeSpecify the device address storing a result of the executed instruction
- DT21Error codeCyclic communication registration node table (Node nos. 1 to 9)
- DT22Error codeCyclic communication normal node table (Node nos. 1 to 9)
- DT23Error codeCyclic communication stop node table (Node nos. 1 to 9)
- DT24Error codeCyclic communication abnormal node table (Node nos. 1 to 9)
- H01Error codeThe PS switch is abnormal
- H02Error codeThe Motor Triac is abnormal
- H04Error codeThe Power Relay is abnormal
- H05Error codeMemory circuit of the I.C is abnormal
- H08Error codeConductance of the thermistor is abnormal
- H09Error codeOpen circuit of P.C. Board's communication line
- R9007Error codeSet when the unit specified by F469 UNITSEL is not the Ethernet communication
- R9351Error codeCyclic communication: All nodes communicating normally =1, Others = 0
- R9352Error codeCyclic communication: All nodes stop =1, Others = 0
- R9353Error codeCommunication abnormal node exists = 1, None = 0
- S1Error codeSpecify a starting device of an area storing data received through CIP message communication
- S2Error codeFor specifying the cyclic communication registration node table
- U11Error codeMalfunction of drain
- U14Error codeMalfunction of water supply
- WR11Error codeCyclic communication stop node table (Node nos. 1 to 9)
- WR101Error codeCyclic communication registration node table (Node nos. 1 to 9)
- WY101Error codeCyclic communication normal node table (Node nos. 1 to 9)