Panasonic ERV All models error codes
Codes
- 1Error code1) Turn to Servo-ON, while disconnecting the motor. If error occurs immediately, replace with a new driver
- 2Error code2) Check that the motor wire (U, V and W) is not shorted, and check the branched out wire out of the connector. Make a correct wiring connection
- 3Error code4) Check the balance of resister between each motor line, and if unbalance is found, replace the motor
- 4Error codepulled out, fix them securely
- 5Error code6) Replace the servo driver. Do not use Servo-ON/Servo-OFF as a means of staring/stopping the operation
- 6kAError codeKaçak Akım Koruma Rölesi (RCCB)
- 7Error codeCommand pulse inhibit input function is assigned to a signal number other than SI10
- 8Error codeBlock operation origin offset (Pr60.49) has been set outside the range in absolute mode origin offset valid setting (Pr60.48 bit 1 =1) under infinite rotation absolute mode when block operation is valid (Pr6.28 ≠ 0)
- 9Error code9) Increase capacity of servo driver and motor. Set up longer acceleration/deceleration time.Reduce the load
- 18Error codeservo driver is defective
- 36Error codedamaged when reading the data from
- 37Error codehas been damaged when reading the
- 38Error codeprohibition inputs (POT and NOT) have
- 43Error codeinitialization time of serial incremental
- 44Error codeturn counter error
- 45Error codeturn counter error
- 47Error codeencoder has been rotated at the specified
- 48Error codeincremental encoder has been detected
- 49Error codeencoder has been detected
- 50Error codescale and the driver has been interrupted
- 51Error code(ALMC) has been turned to 1
- 94Error code3)Although it was servo-off, a block operation was started
- 97Error codeother than Position control (Pr0.01 = 0)
- and3Error codemultiplication during full closed control
- E01Error code
- E02Error code
- E04Error code
- E06Error code
- E07Error code
- E10Error code
- E11Error code
- Pr0Error code2) Set up a larger value to Pr0.14
- S01Error code
- S02Error code
- S03Error code
- S04Error code
- S05Error code
- S06Error code
- S07Error code