Palme halı yıkama makinesi All models error codes
Codes
- 0-2Error code
- 2-4Error code
- A1Error codeWeighing angle sensor
- AL01Error code• Defective coil or YV7/YV9 coil’s supply
- AL06Error code• Incorrect or lack of reception of serial card’s signal to chopper
- AL13Error code• Fault in the chop- per’s EEPROM
- AL32Error code• Low VMN at rest or inconsistent with the applied VMN at work
- AL38Error code• SB1’s auxiliary con- tact faulty
- AL49Error code• Null current on movement request
- AL53Error code• High current at rest
- AL62Error code• Chopper’s thermal protection: temperature over 75°C/167F
- AL73Error code• Short circuit on an electrovalve’s coil or the horn or SB1’s coil
- AL74Error code• SB1 conctactor’s dri- ver faulty or in short cir- cuit
- AL75Error code• SB1 conctactor’s dri- ver malfunctioning or will not close
- AL97Error code• Current out of con- trol
- AL98Error code• The hour shown on the MDI and the chopper differ
- C002Error codeAdjusting a hydraulic block pressure limiter
- C014Error codeReplacing a hydraulic travel motor
- C018Error codeReplacing the end of stroke sensor
- C019Error codeReplacing the motor pump set
- C020Error codeReplacing a hydraulic block valve
- C029Error codeReplacing the balancing valves
- C032Error codeReplacing the hydraulic pump
- C033Error codeReplacing and adjusting the pressure switch
- DP001Error codeFAILURE DETECTION FLOW CHART
- DP002Error codeFAILURE DETECTION FLOW CHART
- DP003Error codeFAILURE DETECTION FLOW CHART
- DP004Error codeFAILURE DETECTION FLOW CHART
- DP007Error codeFAILURE DETECTION FLOW CHART
- DP008Error codeFAILURE DETECTION FLOW CHART
- DP009Error codeFAILURE DETECTION FLOW CHART
- DP010Error codeFAILURE DETECTION FLOW CHART
- DP011Error codeFAILURE DETECTION FLOW CHART
- DP012Error codeFAILURE DETECTION FLOW CHART
- DP013Error codeFAILURE DETECTION FLOW CHART
- DP014Error codeFAILURE DETECTION FLOW CHART
- DP062Error codeFAILURE DETECTION FLOW CHART
- ery50Error codePay attention for the first 50 hours: • Change the hydraulic oil cartridge (see 250 hours frequency).
- FU2Error code• Command fuse : protection of solenoid valves and horn
- G1Error codePressure sensor
- HL1Error code• Light visualising alarm codes (Flashing codes)
- M1Error codeMotorpump unit
- SP1Error codePressure switch
- SQ10Error codeTilt sensor
- YV1Error code• Solenoid valve selecting travel or up & down operations. At rest it controls travel, working it drives lifting wire 18
- YV2AError code• Solenoid valve that controls the forward gear wire 19
- YV2BError code• Solenoid valve that controls backward gear wire 20
- YV3Error code• Solenoid valve that controls high or low travel speed. At rest : low speed, working : high speed wire 21
- YV4Error code• Solenoid valve that controls high or low travel speed ; at rest : low speed, working : high speed ; wire 22
- YV5AError code• Solenoid valve that controls steering right