Omron VFD 3G3MX2 error codes
Codes
- 2-3Error code12 Wire the Inverter Output to Motor
- 3-3Error code21 Current Position Monitor [d030]
- A001Error codeFrequency reference selection
- A002Error codeRun command selection
- b012Error codeRated current Rated current
- b022Error codeRated current x 1.5 (HD) 1.2 (ND) Rated current x 1.5 (HD) 1.2 (ND)
- b025Error code1.50 x Rated current
- b028Error codeRated current
- b040Error codeTorque limit selection
- b041Error codeTorque limit 1
- b042Error codeTorque limit 2
- b043Error codeTorque limit 3
- b044Error codeTorque limit 4
- b045Error codeTorque LADSTOP selection
- b046Error codeReverse rotation prevention selection
- b113Error code0.0 to 800.0 (V)
- b126Error codeRated current
- C030Error codeRated current
- C039Error codeRated current
- C041Error codeRated current Rated current
- C071Error codeCommunication speed selection (Baud rate selection)
- C072Error codeCommunication station No. Selection
- C074Error codeCommunication parity selection
- C075Error codeCommunication stop bit selection
- C076Error codeCommunication error selection
- C077Error codeCommunication error timeout
- C078Error codeCommunication wait time
- C111Error codeRated current
- d009Error codeTorque reference monitor
- d010Error codeTorque bias monitor
- d012Error codeOutput torque monitor
- d060Error codeI-V IM (induction motor) light load mode
- GS1Error codeCurrent OFF
- GS2Error codeCurrent OFF
- H002Error codeMotor parameter selection
- H006Error codeMotor constant (factory set), range is 0 to 255
- H020Error codeDepends on the motor capacity
- H021Error codeDepends on the motor capacity
- H022Error codeDepends on the motor capacity
- H023Error codeDepends on the motor capacity
- H024Error codeDepends on the motor capacity
- H030Error codeDepends on the motor capacity
- H031Error codeDepends on the motor capacity
- H032Error codeDepends on the motor capacity
- H033Error codeDepends on the motor capacity
- H034Error codeDepends on the motor capacity
- H102Error code Standard motor parameter Auto-tuning parameter
- H105Error code0.00 x Rated current to 1.60 x Rated current
- H202Error code2nd motor parameter selection
- H203Error code2nd motor capacity selection