MP All models error codes
Codes
- A4Error codeThe error message is displayed for a while, then the LCD automatically returns to the display before the error occurrence
- E04Error codeKartuş tanınmadı
- E07Error codeKartuş doğru pozisyonda takılı değil
- E08Error codeMürekkep emici (atık mürekkep) hatası
- E14Error codeKartuş tanınmıyor
- E20Error codeAğ (network) bağlantı hatası
- H1Error codeFailed delta-pressure
- H3Error codePump B1 ; loss of power
- H4Error codePump B1 ; impeller
- or8Error codeThe error message is displayed for a while, then the LCD automatically returns to the display before the error occurrence
- QK1-150Error code- The red screws securing the paper feed motor are allowed to be loosened. (DO NOT loosen any other red screws.)
- QM2-292Error codeAt replacement: 1. Apply grease to the sliding portions. [See 3-3. Adjustment / Settings, (2) Grease application.] After replacement: 1. Correct the CD / DVD and automatic print head alignment sensors. [See 3.3. Adjustment / Settings, (5) Service mode.] 2. Check the ink system function. [See 3.3. Adjustment / Settings, (5) Service mode.] 3. Perform the print head alignment in the user mode
- QM2-307Error code- Before removal of the logic board ass'y, remove the power cord, and allow for approx. 1 minute (for discharge of capacitor's accumulated charges), to prevent damages to the logic board ass'y. - Before replacement, check the waste ink amount (by service test print or EEPROM information print). If the waste ink amount is 7% or more, also replace the ink absorber kit when replacing the logic board ass'y. [See 3-3. Adjustment / Settings, (5) Service mode, for details.]
- QY5-014Error codeThe received image data was invalid in infrared communication from a mobile phone
- x11Error codeThe error message is displayed for a while, then the LCD automatically returns to the display before the error occurrence