Monarch devir ölçer takometre All models error codes
Codes
- Err49Error codeElevator door closing failure
- Err50Error codeContinuous loss of leveling signals
- Err51Error codeCAN communication failure
- Err52Error codeoutbound communication failure
- Err53Error codeDoor lock failure
- Err54Error codeTroubleshooting start-up overcurrent
- Err55Error codechange-over stop failure
- Err56Error codeelevator door opening and closing failure signals
- Err57Error codeSPI communication failure
- Err58Error codePosition protection switch abnormal
- Err62Error codeAnalog Disconnect
- Err63Error codeMain board, driver board, display board not bound
- Err64Error codeThis fault is reported when the UCMP function is enabled or accidental car movement occurs
- Err65Error codeAccidental movement of the car
- Err66Error codeBrake force detection faults
- Err80Error codeDebug authorization code expires
- Err81Error codeTemporary authorization code expires
- Err83Error codeIoT without communications
- Err84Error codeIoT without communication for a long time
- Err88Error codeFactory automatic test function
- F1Error codeMotor parameters
- F1-01Error codeRated motor power
- F1-02Error codeRated motor voltage
- F1-03Error codeRated motor current
- F1-04Error codeRated motor frequency
- F1-05Error codeRated motor speed
- F1-11Error code0: No operation 1: With-load auto-tuning 2: No-load auto-tuning 3: Shaft auto-tuning 1 4: Shaft auto-tuning 2 5: Synchronous motor static auto-tuning
- F1-25Error code0: Asynchronous motor 1: Synchronous motor
- F2Error codefault reset and fault code display
- F3Error codeRunning control parameters
- F8Error codeEnhanced function parameters
- F8-09Error codeEmergency evacuation operation speed at power
- F8-10Error codeEmergency evacuation operation mode at power failure
- F9-03Error codeCurrent year
- F9-04Error codeCurrent month
- F9-05Error codeCurrent day
- F9-06Error codeCurrent hour
- F9-07Error codeCurrent minute
- S1LED codeThis indicator blinks when communication with the controller is normal
- S2LED codeThis indicator blinks when the RS485 communication network is normal
- S3LED codeThis indicator blinks when communication with the host computer is normal
- x1Error codeTepsi 1'deki kart (tepsi 2 ise “2”) hatalı