Mimaki plotter kesim makinesi All models error codes
Codes
- 4-12Error codeRegisters the faulty nozzle identified by “PRINT”
- ERR27Error codeERR27 BUFFERover
- ERR38Error code
- M9044Error codeBe careful not to touch the cutter or grit rollers while this machine is operating. Failure to do so may result in injury
- ROR04Error codeAn error occurred in the main PCB FROM
- ROR122Error codeSDRAM is defective
- ROR128Error codeHead control circuit board is defective
- ROR130Error codeHead data transferring sequence error occurred
- ROR146Error codeSequential number abnormality of the event log occurred
- ROR186Error codeAn error is detected on the waveform printed on
- ROR192Error codeAn error occurred in the COM16/32IO PCB
- ROR201Error codeThe machine received some data other than print data. Or, an error occurred in the transmitted print data
- ROR202Error codeAn error occurred in the transmitted print data
- ROR304Error codeAn error occurred in the communication of USB
- ROR401Error codeAn excessive load was applied to the X motor
- ROR402Error codeAn excessive load was applied to the Y motor
- ROR403Error codeAn error due to an excessive current of the X motor was detected
- ROR404Error codeAn error due to an excessive current of the Y motor was detected
- ROR425Error codeA problem has occurred in the option tension bar. • The tension bar control position has deviated from the lowest point for a certain period
- ROR429Error codeLIMIT position of the tension bar has been detected. • The tension bar control position has deviated from the highest point for a certain period
- ROR509Error codeAn error occurred in the control position
- ROR528Error codePump sensor detection error
- ROR608Error codeThe ink cartridge IC chip cannot be cor- rectly read
- ROR702Error codeThe thermistor connection of a heater is defective
- ROR710Error codeThe temperature abnormality of the heater has been detected. When this error occurred and if the tem- perature abnormality cannot be resolved, the power supply of the machine is forcibly turned off
- ROR901Error codeDue to a certain error, the function can- not be performed