Markasi-Belli-Degil All models error codes
Codes
- E-40Error codeHızlanma çok düşük Rotorun doğru yüklenmiş olduğundan
- E4Error code3. Check home position of right SAPE
- E37Error codeThe code indicates CAN error, Fault trace and rectify the fault.
- E37-07Error code9.00 9.85 E54 E28
- E38Error codeAIR FILTER FULL The code indicates air filter on Clean or replace filter.
- E38-07Error code9.86 10.4 E55 E29
- E39Error codeY100 P.CONTROL The code indicates open circuit Check contact and cable for open
- E39-07Error code10.5 12.0 E56
- E363Error codeOPTIMA left side scanner self test fail or CCD not calibrated or zero mark not detected
- E364Error codeOPTIMA right side scanner self test fail or CCD not calibrated or zero mark not detected
- E365Error codeOPTIMA rear scanner self test fail or CCD not calibrated or zero mark not detected
- E366Error codeC123 OPTIMA main camera board memory self test failure
- E367Error codeC123 OPTIMA motor power supply missing or out of range
- E368Error codeC123 OPTIMA main camera board A/D converter failure
- E369Error codeC123 OPTIMA main shaft encoder zero mark detection failure or
- E370Error codeC123 OPTIMA inner CCD signals failure
- E371Error codeC123 OPTIMA inner scanner memory not responding
- E372Error codeC123 OPTIMA inner scanner memory not valid
- E373Error codeOPTIMA inner scanner not calibrated
- E374Error codeOPTIMA inner motor current sink or power supply failure
- E375Error codeOPTIMA inner scanner zero mark not detected
- E376Error codeOPTIMA inner motor missing steps
- E377Error codeOPTIMA inner laser current sink or power supply failure
- E378Error codeOPTIMA inner laser modulation failure
- E380Error codeOPTIMA outer CCD signals failure
- E381Error codeOPTIMA outer scanner memory not responding
- E382Error codeOPTIMA outer scanner memory not valid
- E383Error codeOPTIMA outer scanner not calibrated
- E384Error codeOPTIMA outer motor current sink or power supply failure
- E385Error codeOPTIMA outer scanner zero mark not detected
- E386Error codeOPTIMA outer motor missing steps
- E387Error codeOPTIMA outer laser current sink or power supply failure
- E388Error codeOPTIMA outer laser modulation failure
- E390Error codeOPTIMA rear CCD signals failure
- E391Error codeOPTIMA rear scanner memory not responding
- E392Error codeOPTIMA rear scanner memory not valid
- E393Error codeOPTIMA rear scanner not calibrated
- E394Error codeOPTIMA rear motor current sink or power supply failure
- E395Error codeOPTIMA rear scanner zero mark not detected
- E396Error codeOPTIMA rear motor missing steps
- E397Error codeOPTIMA rear laser current sink or power supply failure
- E398Error codeOPTIMA rear laser modulation failure
- E400Error codeOPTIMA pull index user calibration failure
- E401Error codeSupply air temperature sensor Line breakage
- E402Error codeData recorder supply air Line breakage
- E403Error codeReturn air temperature sensor Line breakage
- E404Error codeData recorder return air Line breakage
- E405Error codeDischarge temperature sensor Line breakage
- E406Error codeSuction gas sensor (SGS) Line breakage
- E407Error codeEvaporator inlet sensor (EIS) Line breakage