Makita vidalama All models error codes
Codes
- E01XError codehen the robotic cleaner goes through a low gap, the robotic eaner may get caught in the gap, displaying this notification
- E09XError codeAre the cliff sensor dirty?
- E10XError codeIt is a malfunction of the bumper sensor
- E140Error codeIs the LiDAR sensor blocked by a cloth or dirty?
- en10Error codeMessage Codes Care Safety Instructions If the message Error does not disappear • Clean the device with a damp, soft cloth. The person responsible for the instrument after switching on the device repeatedly, • Never immerse the device in water. must ensure that all users understand contact the dealer. • Never use aggressive cleaning agents these directions and adhere to them. If the message InFo appears with a or solvents. Areas of responsibility number, press the Clear button and observe the following instructions: Responsibilities of the manufacturer of the original equipment: No. Cause Correction Makita Corporation Anjo, 204 Calculation error Perform measurement Aichi 446-8502 Japan / again. Makita, Jan-Baptist Vinkstraat 2, 3070, 252 Temperature too Let device cool down. Belgium high Internet: www.makita.com 253 Temperature too Warm device up. low The company above is responsible for supplying the product, including the User 255 Received signal too Change target surface weak, measuring (e.g. white paper). Manual in a completely safe condition. time too long The company above is not responsible for 256 Received signal too Change target surface third party accessories. high (e.g.
- en12Error codeSafety Instructions FCC statement (applicable in U.S.) Laser classification Labelling This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential instal- lation.This equipment generates, uses and The device produces visible laser beams, can radiate radio frequency energy and, if which are emitted from the instrument: not installed and used in accordance with It is a Class 2 laser product in accordance ® the instructions, may cause harmful inter- LD050P ference to radio communications. with: Makita xxxxxxx xxxxxxx xxxxxxx • IEC60825-1 : 2014 „Radiation safety of However, there is no guarantee that inter- laser products“ Made in Hungary Batteries: 2 x AAA ference will not occur in a particular instal- lation. If this equipment does cause Laser Class 2 products: Complies with 21CFR 1040.10 and 1040.11 except for deviations pursuant to harmful interference to radio or television Do not stare into the laser beam or direct it Laser Notice No. 50, dated June 24, 2007 reception, which can be determined by towards
- han15Error codeIf you have an implantable cardiac pacemaker or an implantable defibrillator, use this product more than 15 cm away from the implantation site. • Radio waves may affect the operation of a medical device and can cause malfunction of the medical device