JennAir All models error codes
Codes
- "C"Error code
- 5AError code
- 27Error code
- 30Error code
- ERError codeThis error code indicates a problem with the electronic control board. Unplug the refrigerator and check the control board for any damage or loose connections. If the control board appears to be in good condition, it may need to be replaced
- F1Error codeThis error code indicates a problem with the touchpad or the control panel. Unplug the microwave and check the touchpad for any damage or looseness. If the touchpad appears to be in good condition, the control panel may need to be replaced
- F1EError codeControl board EEPROM read/write failureCauses: Control board memory chip corrupted, Power-surge damage, Board component failure
- F2EError codeKeypad ribbon disconnected or unresponsiveCauses: Touch-panel ribbon unseated, Cable pins corroded, Display board fault
- F3Error codeThis error code indicates a problem with the oven temperature sensor. Unplug the microwave and check the sensor for any damage or looseness. If the sensor appears to be in good condition, it may need to be replaced
- F3EError codeOven temperature sensor openCauses: RTD probe failed open, Rear sensor connector loose, Sensor lead heat-damaged
- F5Error codeThis error code indicates a problem with the door latch. Check the door latch for any damage or looseness, and make sure that it is properly engaged when the door is closed. If the latch appears to be in good condition, it may need to be replaced
- F5EError codeSelf-clean door lock will not lockCauses: Latch motor burned out, Lock lever bent or jammed, Door warped from clean-cycle heat
- F6EError code
- F9Error code
- F9EError codeDoor lock motor faultCauses: Latch motor stalled partway through its travel, Lock cam bent or bound by debris, Latch drive gear teeth stripped, Position switch failing to report the latch state
- FFError codeThis error code indicates a problem with the freezer fan. Unplug the refrigerator and check the freezer fan for any damage or looseness. If the fan appears to be in good condition, it may need to be replaced
- PFError codeThis error code indicates a power failure. If you see this code, check to make sure that the refrigerator is plugged in and that the outlet is functioning properly. If the power is on and the outlet is working, the control board may need to be replaced
- rdError codeThis error code indicates a problem with the defrost system. Unplug the refrigerator and check the defrost heater and sensor for any damage or looseness. If these components appear to be in good condition, they may need to be replaced