Hyundai CE Ekskavatör All models error codes
Codes
- 3AError codewater leakage sensor No. 1 is faulty
- 3CError codedew condensation sensor defective
- 3HError codewater leakage sensor No. 2 is faulty
- 6FError codethe simplified control panel is faulty
- A1Error codethe printed circuit board of the indoor unit is faulty
- A2Error codefan motor blocked
- A4Error codedefective heat exchanger
- A5Error codeoverheating of the heat exchanger
- A6Error codefan motor overloaded
- A7Error codeblind drive defective
- A8Error codecurrent overload (general)
- A9Error codeelectronic expansion valve defective
- AAError codeheater overheated
- AHError codepump blocked
- C0Error codegeneral sensor malfunction
- C3Error codethe drainage level sensor is faulty
- C4Error codeheat exchanger temperature sensor 1 defective
- C5Error codeheat exchanger temperature sensor 2 defective
- C6Error codethe fan motor is overloaded, the sensor is blocked
- C7Error codeblind drive sensor is out of order
- CCError codebreakage of the humidity sensor
- CEError codedamage to the radiation sensor
- CFError codehigh pressure sensor out of order
- CHError codethe pollution sensor is working
- CJError codethe temperature sensor on the remote control does not work
- cm2Error codeDefective hydraulic system Defective EPPR valve Defective MCU Short circuit or poor connection between CN-50 -CN-75 Defective EPPR valve
- CN-51Error codeClogged air filter or defective switch Short circuit in wiring harness Defective MCU
- E1Error codethe printed circuit board of the outdoor unit is faulty
- E3Error codeHPS (high pressure sensor) is working
- E4Error codeLPS (low pressure sensor) is working
- E5Error codethe compressor motor is overloaded, the overheating relay has tripped
- E6Error codecompressor motor blocked by overcurrent
- E7Error codefan motor blocked by overcurrent
- E8Error codecurrent overload (general)
- E9Error codeelectronic expansion valve defective
- ECError codepeak water temperature
- F3Error codeabnormally high temperature of the discharge pipe
- F6Error codeunacceptable temperature in the heat exchanger
- FAError codeunacceptable charge air pressure
- FCError codeunacceptable intake air pressure
- FEError codeinvalid oil pressure
- FHError codeoil overheating
- H0Error codegeneral sensor malfunction
- h2Error codeair temperature sensor defective
- h3Error codesystem power supply is faulty
- h4Error codehigh pressure sensor defective
- h5Error codethe low pressure sensor is faulty
- H6Error codecompressor overload, system blocked
- H7Error codefan overload, system locked
- H9Error codeabnormal intake air temperature