Extech multimetre All models error codes
Codes
- P16BError codeECU Fast ADC fault (knock detection line)
- P16CError codeFault of ECM ADC
- P160EError codeThrottle Actuator - Controller Fault - digital position control below limit
- P1503Error codeTOPS switch short circuit to 12 V
- P1504Error codeTOPS switch short circuit ground
- P1505Error codeTOPS switch fault non plausible state
- P1506Error codeTOPS switch open circuit
- P1550Error codeO.T.A.S. sensor voltage not plausible
- P1606Error codeECM ADC fault - exchange ECM
- P1610Error codeThrottle Actuator - Power Stage fault
- P1611Error codeThrottle Actuator - Power Stage fault
- P1612Error codeThrottle Actuator - Power Stage fault
- P1613Error codeThrottle Actuator - Power Stage fault
- P1615Error codeThrottle Actuator - Position monitoring fault
- P1616Error codeThrottle Actuator - Default position check or learning fault
- P1654Error codeVoltage of D.E.S.S. key switch out of range
- P1657Error codeElectrical fault of D.E.S.S. key communication line
- P1658Error codeFaulty D.E.S.S. key communication
- P1661Error codeiBR malfunction
- P1662Error codeiBR torque request is not plausible
- P2080Error codeExhaust temperature not plausible
- P2081Error codeExhaust temperature sensor fault
- P2159Error codeTAS (Throttle Accelerator sensor) signal not plausible
- P2428Error codeHigh exhaust temperature detected
- Pin12Error codePin 11 (Black)
- to2500Error codeComplete failure of TAS sensor (both internal sensors)
- to3200Error codeNOTE: When one of these fault is active, OTAS and iBR will continue to monitor their input signals. However, since the engine speed is limited, the OTAS will not be activated. Also, since the ECM cannot control the throttle body, the iBR might come in fault because the ECM does not react to his specific torque request. It all depends on the circumstances when the iBR is applied. (vehicle and engine speed will be a factor)
- U016AError codeLoss of vehicle speed
- U16AError codeCluster CAN Time out error-Missing CAN ID 514h
- U0129Error codeCAN communication error between ECM and iBR module
- U0401Error codeECM CAN messages time out or validity
- U0457Error codeCluster CAN messages timeout or validity