Error code

Ziraat ATM atm cihazı All models code D00A

No approved translation for this record yet; showing the original text.

Meaning

ERROR DESCRIPTION FS omitted (after total cash dispense amount in day close). FS omitted (after total non cash dispense amount in day close). FS omitted (after surcharge amount in day close message). FS omitted (after surcharge in configuration message). ETX omitted (from configuration message). Modem is not responding. No Connection. ENQ not received from host. Transmission error. NAK sent 3 times to host. Modem connection time out - host not responding. Modem cannot support connection - excessive line noise (usually D1704/06) No dial tone. No answer. Phone line busy. Modem initializing error. EOT not received from host. Network Connection RMS port failure, response time out, modem failure, no dial tone. Current Number of bill is 0. No Surcharge Owner set. No Surcharge Amount. No refresh time set when advertisement is enabled. No Advertisement text when advertisement is enabled. Dispense limit set error (less than 25 notes) Denomination Set error. Fast Cash Set error (exceeded dispense limit). Master Key index is invalid

Member details

Signed-in members see the LED pattern and how to read the code with the remote control on eligible records.

View details as a member

Possible causes

CORRECTIVE ACTION Verify that version of ATM Software matches host processor. Contact host processor. Verify that version of ATM Software matches host processor. Contact host processor. Verify that version of ATM Software matches host processor. Contact host processor. Verify that version of ATM Software matches host processor. Contact host processor. Contact host processor. Verify modem function. Verify modem function. Contact host processor. Verify modem function. Verify host phone number - See D170x. Verify host phone number - verify modem speed - See D170x. If consistent, it could be a defective modem. Phone line connected to ATM will not support Data-communication. In line filter may fix this. Excessive EMI emissions from outside source (neon sign, freezer). Verify that incoming phone line is plugged into “line” rather than “Phone” on mainbaord. Phone line is in use or is being shared with another phone device (FAX, POS, phone) Verify host phone number - See D170x Verify host phone number - call line with handset and check for busy signal - See D170x Check modem. Contact host processor. See page 3.33 of Operator Manual Verify RMS settings (Host Setup) - See D170x Load notes in

Solution

Solution steps are available to members and are not shown on this page. Answer the questions to open the solution.

Remote technician support

Get help from a technician over a video call.

Send a message Voice call Video call