Error code

Yaskawa endüstriyel All models code 6

No approved translation for this record yet; showing the original text.

Meaning

㧭㧰㧶㧭㨐㨢㨍㨚㨏㨑㨐㧭㨀㧼㨚㧝㧜㧟㧩㧜㧜㧟㧜㧜㧼㨚㧝㧜㧜㧩㧜㧜㧠㧜㧜㧼㨚㧝㧜㧝㧩㧜㧜㧞㧜㧜㧼㨚㧝㧠㧝㧩㧜㧜㧡㧜㧜 Display example: After the moment of inertia is calculated

Member details

Signed-in members see the LED pattern and how to read the code with the remote control on eligible records.

Possible causes

Calculates the moment of inertia. Press the Key if a positive (+) value is set in STROKE (travel distance), or press the Key if a negative (-) value is set. Calculation of the moment of inertia will start. While the moment of inertia is being calculated, the set value for Pn103 will flash and “ADJ” will flash instead of “RUN.” When calculat- ing the moment of inertia is completed, the display will stop flashing and the moment of inertia is dis- played. The servomotor will remain ON, but the auto run operation will be stopped temporarily. Notes: • The wrong key for the set travel direction is pressed, the calculation will not start. • If the moment of inertia is not calculated (Jcalc = OFF), the set value for Pn103 will be displayed. • If "NO-OP" or "Error" is displayed during opera- tion, press the Key to cancel the function. Refer to (2) Failure in Operation and take a cor- rective action to enable operation

Solution

Solution steps are available to members and are not shown on this page. Answer the questions to open the solution.

Remote technician support

Get help from a technician over a video call.

Send a message Voice call Video call