Weihong cnc kontrol ünitesi All models error codes
Codes
- 1-16Error codeMENP
- DB44Error codeSignal Input signal anode common port Fault signal output+ Servo enable input Alarm clear signal input Fault signal output- Pulse command signal input+ Pulse command signal input- Direction/pulse command input + Direction/pulse command input- Signal differential output + Signal differential output - Signal differential output + Signal differential output - Signal differential output + Signal differential output - BRAKE+ BRAKE-
- F00Error codeControl mode selection
- F0fError codeElectronic gear ratio numerator
- GX15Error codeE-stop alarm signal input
- P1-32Error codeMotor stop mode selection
- P2-30Error codeServo ON (SON) setup
- P2-51Error codeServo ON (SON) setup
- PA12Error codeNumerator of position command pulse ratio
- PA20Error codeInvalid input on the end of the stroke
- Pn000Error codeDirection selection Control mode selection
- Pn001Error codeSelection servo off or alarm stop mode
- Pn50EError codeSelection function
- Pn50FError codeSelection function
- Pn201Error codeEncoder cycle-divided ratio (Pulse output No. per motor cycle by encoder after cycle-divided)
- Pn202Error codeElectronic gear ratio (numerator)
- Pn506Error codeServo off, time delay of brake when motor stops
- Pr0Error codeCommand pulse counts per one motor revolution
- Pr008Error codeCommand pulse No. per motor circle
- Pr011Error codeOutput pulse No. per motor circle