Textron GSE yer destek ekipmanı gpu All models error codes
Codes
- B10Error codeSensor exhaust manifold temperature
- CB2-6Error codeProtective circuit-breaker control voltage
- G5000Error codeComplete a visual inspection of the G5000 electrical wiring located on the aft pressure bulkhead
- GDL69Error codeThe system has detected a failure in the GDL 69A
- GDR66Error codeFollow this procedure to enable the optional GDR 66 VHF Voice/ Datalink Transceiver, which provides support for Link 2000+, FAA Datacomm, FANS 1/A and ACARS applications
- GSR56Error codeFollow this procedure to enable the optional GSR 56 #2 satellite receiver when installed as a stand-alone option providing support for ACARS and FANS 1/A
- HC3Error codeOil Pressure Low LH
- IN1Error codeFuel F/W S/O Valve LH
- IN2Error codeHyd F/W S/O Valve LH
- IN3Error codeBleed Air Overheat LH
- IN5Error codeFuel X-Feed Valve Closed
- IN6Error code
- IN12Error codeGeneric 18 Engine Sync - FAN
- IN14Error codeACM Overheat
- Out981Error code1. 2. Verify Electrical bond of PC034 and PC061 connectors (harness side) per Section 5.24. 3. Perform a visual inspection of the fuel wiring in the wheel well area: a) All electrical connectors, backshells and strain-reliefs are properly secured. b) Wire terminal lugs and shields are properly secured to connector backshells and ground studs. c) Evidence of overheating is not present at any of the connections. d) Physical damage to ground studs or terminal blocks is not evident
- S1Error codeThe system has detected a failure in G/S1 receiver
- S2Error codeThe system has detected a failure in G/S2 receiver
- SW5Error codeCurrent limit POT
- uke725Error codeVoltage Source