Error code

Stryker All models code A03

No approved translation for this record yet; showing the original text.

Meaning

4. Place system PCBA on PCBA stack, aligning header pins with holes. 5. Assemble PCBAs together, gently pressing near headers until pins are fully engaged and board is bottomed on screw bosses. 6. Install 3 screws, using a torque driver with a P-1 bit. 7. Install the PCBA stack as described in Installing the PCBA Stack, steps 1-12, 14-16. Steps 8-10 are only required for devices configured with temp/IP. 8. Install temp/IP cable routing clip by pressing fully into hole in PCB until it snaps in. 9. Remove 2 adhesive liners from insulator, and apply insulator to system PCBA as shown below, pressing firmly in place. 10. Connect temp/IP cable connector, if equipped, to system PCBA J211, and place cable under routing clip

Member details

Signed-in members see the LED pattern and how to read the code with the remote control on eligible records.

View details as a member

Solution

Solution steps are available to members and are not shown on this page. Answer the questions to open the solution.

Remote technician support

Get help from a technician over a video call.

Send a message Voice call Video call