Star All models code U1-18

Meaning

Drive capacity and value set to o2-04 do not match. Parameters were set outside the allowable setting range. A contradictory setting is assigned to multi- function contact inputs H1-01 through to H1- 07. • The same function is assigned to two inputs (this excludes “External fault” and “Not used”) •

Member details

Signed-in members see the LED pattern and how to read the code with the remote control on eligible records.

View details as a member

Possible causes

Drive capacity and value set to o2-04 do not match. Parameters were set outside the allowable setting range. A contradictory setting is assigned to multi- function contact inputs H1-01 through to H1- 07. • The same function is assigned to two inputs (this excludes “External fault” and “Not used”) • Input functions which require the setting of other input functions were set alone. • Input functions that are not allowed to be used simultaneously have been set. • The run command source (b1-02) or fre- quency reference source (b1-01) is set to 3 but no option board is installed. • The frequency reference source is set to pulse input but H6-01 is not 0. Settings to multi-function analog inputs H3- 02 and H3-10 and PID functions conflict. • H3-02 and H3-10 are set to the same value (this excludes settings “0” and “F”) • PID functions have been assigned to both analog inputs and the pulse input at the same time. A function has been set that cannot be used in the control mode selected (might appear after control mode change) The V/f pattern setting is incorrect.

Solution

Solution steps are available to members and are not shown on this page. Answer the questions to open the solution.

Remote technician support

Get help from a technician over a video call.

Send a message Voice call Video call