Priva sera otomasyon paneli All models error codes
Codes
- 1Error codeSupply voltage
- 2Error codeSignal sensor
- 2xError codeMeasuring error at 15 mS
- 3Error codeGND sensor
- 4Error codeWind speed sensor
- 4xError codeMeasuring error at 15 mS
- 5Error code• continuously off: system OK • continuously on: system OK, the production jumper has been installed. • 1x flashing signal: the display is not responding • 2x flashing signal: no ADC interrupt • 4x flashing signal: the Test outputs menu is still active. The number of flashing signals is added together. Thus: 6 flashing signals means: ADC is defective, and the operating mode for testing the outputs is still active
- 6Error codeLinear Light Sensor or Radiation sensor (only with a geographical situation more northerly than 15° NL or more southerly than 15° SL; otherwise place these sensors on a separate mast)
- 7Error code24 VDC
- 9Error code24 VDC
- 11Error code24 VDC
- 13Error codeGND
- 17Error codeWS OUT
- 18Error codeWR OUT
- 20Error codeBT+
- AI-1Error codesensor signal
- C4Error codePower supply voltage (24 VDC) I/O bus out RS485 port Ethernet port Shield (for Ethernet ports) Digital inputs Universal inputs Analogue outputs Relay outputs USB host USB device
- DCError codedirect current
- E4Error codeCommunication malfunction between main control board and display board
- MB1Error codesensor signal sensor 1
- MB2Error codesensor signal sensor 2
- MX34Error codePower supply voltage (24 VDC) I/O bus in and out Digital inputs Universal inputs Analogue outputs Relay outputs
- P2-7Error codeFan (DC) DC power supply only
- P2-8Error codeFan (DC) DC power supply only
- PH1Error codesensor signal pH sensor 1
- PH2Error codesensor signal pH sensor 2
- put0VError codeGND sensor
- S1Error codeElectric Heat Only
- S2Error codeTemperature Display in℃
- S6Error codeFan Continuous Run for Heating
- S7Error codeFan Continuous Run for Cooling
- T90Error codeSensor response time (T90)
- WI2Error codeSensors or power supply